A. To give indications and test to the wing/body overheat system, 115v ac power must be connected. When installing an element, do not bend the element unless the bend radius is less than one inch. If the bend radius is less than one inch, damage to the eleme

B. For the indications and test of the wing/body overheat system, 115v ac power must be ON. When you install an element, do not bend the element until the bend radius is less than one inch. If the bend radius is less than one inch, damage to the element can

C. 115v dc power must be supplied for the indications and test of the wing/body overheat system. When you install an element, do not bend the element radius less than one inch. If you bend the radius less than one inch, damage to the element can occur.

点击查看答案

Data shall be presented as landing distance versus outside air temperature, altitude and wind.

A. 数据应显示外部大气温度、高度和风与着陆距离的关系。

B. 数据应以着陆距离与外界空气温度、高度和风向的关系来表示。

C. 数据应考虑与外界空气温度、姿态和风的关系。

点击查看答案

The operator uses an external joystick and control panel to set the configuration and operate the system.

A. In order to set the configuration and operate the system, the operator uses an external joystick and control panel.

B. An external joystick and control panel is used to make the configuration and operate the system.

C. To operate an external joystick and control panel for the configuration and the system operation.

点击查看答案

Manually position the outflow valve to full OPEN.

A. 按手册将外流活门定位到全开位。

B. 外流活门的人工位置是全开位。

C. 将外流活门人工置于全开位。

点击查看答案

缓慢地把RAT完全放出，并确保它不接触其他部件。

A. Slowly and fully extend the RAT and make sure that it does not touch other parts.

B. Quickly and fully retract the RAT and make sure that it does not touch other parts.

C. Slowly and carefully extend the RAT and make sure that it does not attach to other parts.

点击查看答案

注意不要让酸接触皮肤。

A. Be careful not to get acid on your skin.

B. Prohibit not to get acid on your skin.

C. Be careful not to get alcohol on your skin.

点击查看答案

Make sure that there is clearance between the lever and the roller.

A. 保证手柄和滚柱之间是干净的。

B. 确保杆和滚柱之间有连接。

C. 确保杆和滚轮之间有间隙。

点击查看答案

用适用的公式计算压力。

A. Proper recipe shall be adopted to measure the pressure.

B. The pressure shall be estimated by using accurate equation.

C. Calculate the pressure with the applicable formula.

点击查看答案

当逆时针转动排放活门时，没有液体流出, 除非按压该活门。

A. Turn the drain valve counterclockwise to cause the fluid to stop flowing before the valve is pushed.

B. When you turn the drain valve counterclockwise, no fluid will flow until you push the valve in.

C. Make sure there is no fluid flowing after the valve is pushed, then turn the drain valve clockwise.

点击查看答案

类似热门题库

电力安全知识考试

35-1-营销安规-通用专业、营业专业、市场专业、电能计量专业