A、 Inform the administration of the problem.
B、 Announce the problem to the operator.
C、 Tell the manufacturer about the problem.
答案：C
A、 Inform the administration of the problem.
B、 Announce the problem to the operator.
C、 Tell the manufacturer about the problem.
答案：C
A. 该任务通过调节变频起动机发电机空气/油热交换器上的空气控制活门不工作状态使飞机恢复到正常状态。
B. 在变频起动机发电机空气/油热交换器上的空气控制活门不工作的情况下，该任务在操作后使飞机恢复到正常状态。
C. 该任务使变频起动机发电机空气/油热交换器上的空气控制活门失效状态恢复，从而使飞机恢复到操作后的通常状态。
A. If the unit is not modified, its service life will be possibly shorter.
B. Without the modification of the unit, its service life is likely shorter than present.
C. Without the modification, it is possible that the service life of this unit will be shorter than usual.
A. Clamps should be spaced at intervals not exceeding 24 inches. Clamps on wire bundles should be selected so that they have a snug fit without pinching wires.
B. Pins should be spaced at intervals not exceeding 24 inches. Pins on harness should be selected so that they have a snug fit without pinching wires.
C. Pins should be spaced at intervals not exceeding 24 inches. Pins on harness should be selected so that they have a snug fit without scratching wires.
A. The introduction should be included in an alphabetical index by subject.
B. An alphabetical index by subject is to be included in the introduction.
C. The introduction includes an alphabetical index subject.
A. The ailerons are located to the outside rare edge of each wing.
B. The spoilers are located on the outside rare edge of each wing.
C. The ailerons are located on the outboard trailing edge of each wing.
A. Use the same hydraulic fluid to lubricate the engine and all auxiliary equipment.
B. The lubricant used on engine and all auxiliary equipment are identical.
C. The identical grease is used to lubricate the engine and all auxiliary equipment.
A. When it is unlikely that the temperature decreases to -20 ℃, remove the batteries.
B. If it is possible that the temperature will decrease to -20 ℃, remove the batteries.
C. If it is possible that the temperature will decrease to -20 ℃, cut the cells.
A. Metal objects attract magnetic interference.
B. Magnetic interference can occur to the metal objects.
C. Metal objects can cause magnetic interference.
A. Landing gear position has no effect on stall speeds.
B. The position of the landing gear doesn＇t influence the surging speed.
C. The idle speed is not effected by the landing gear position.
A. 本课件仅适用于特定的操作系统。
B. 本软件只适用于特殊的操作系统。
C. 本软件仅与指定的操作系统兼容。
