A、 A separate document should be prepared for FAA approved airworthiness limitations which are excluded in the primary maintenance manual.
B、 FAA approved airworthiness limitations shall be prepared as a separate document for inclusion in the principal maintenance manual.
C、 FAA approved airworthiness limitations must be contained as an integrated documentation for inclusion in the main maintenance manual.
答案：B
A、 A separate document should be prepared for FAA approved airworthiness limitations which are excluded in the primary maintenance manual.
B、 FAA approved airworthiness limitations shall be prepared as a separate document for inclusion in the principal maintenance manual.
C、 FAA approved airworthiness limitations must be contained as an integrated documentation for inclusion in the main maintenance manual.
答案：B
A. 曲线半径必须至少为8mm。
B. 圆的直径必须最小为8mm。
C. 曲线的直径必须最大为8mm。
A. 油门杆的快速移动将引起喘振。
B. 节流阀的快速运动将造成抽吸现象。
C. 快速移动节气门将造成通气。
A. 移动装有隔热毯的喷射管或排气锥时要小心。
B. 当你移动喷气式管道或带有绝缘垫的排气孔时要小心。
C. 小心地移动发射管或排气口的保温垫。
A. Briefly describe and explain principle of operation of any new kinds of flight instruments.
B. Briefly introduce the operation principal of any new kinds of flight apparatus.
C. Briefly describe and explain the operation principle of any new kinds of flight displays.
A. 仔细评估损伤区域。
B. 仔细测量损伤区域。
C. 仔细评估磨损区域。
A. “重大的检查条件”用于描述裂纹检查时的最小尺寸以及其他检查条件时的磨损极限、腐蚀坑深度等。
B. “重大的检查项目”用于描述裂纹检查时可检测到的最小裂纹尺寸以及其他检查项，如磨损极限、腐蚀坑深度等。
C. “重大的检查状况”用于描述裂纹检查中预期发现的最小尺寸。对于其他检查条件，指定磨损极限和腐蚀坑深度等
A. If the cable twists, disconnect the two connectors.
B. If the wire bents, break the two connectors.
C. If the cable wire breaks, disconnect both ends of the connectors.
A. 系统的这一部分用来消除或防止螺旋桨结冰。
B. 系统利用这个部分来解除或阻止叶轮上的冰形成。
C. 这个部分的系统用来排除或阻止冰在推进器上面形成。
A. Replace the defective booster pump.
B. Remain the present booster pump.
C. Recharge the failed booster pump.
A. In order to correctly connect the parts together, you have to put weight on the panel surface.
B. Apply weight on the surface of the patch to make sure that the parts bond correctly.
C. To make sure the parts are engaged properly, you should pressurize the plate surface.
