A、 The limitation applies to all editions of the specification.
B、 This restriction corresponds to all versions of the specification.
C、 The limitation responds to all versions of the regulation.
答案：A
A、 The limitation applies to all editions of the specification.
B、 This restriction corresponds to all versions of the specification.
C、 The limitation responds to all versions of the regulation.
答案：A
A. These must be shown on the wiring diagram under some specific conditions and wires are colour coded.
B. Wires are coded in color in certain condition and these should be marked on the wiring diagram.
C. In some cases, wires are color coded and these should be indicated on the wiring diagram.
A. Lubricate one side of the washers.
B. Lubricate one side of the seals.
C. Wash one side of the washers.
A. Right wing inboard flap control cable at control mechanism located in right rear wheel well is incorrectly routed and kinked.
B. The right rear wheel well right inner flap control mechanism controls the wrong alignment and is knotted.
C. Right wing inner flap control cable at control mechanism after right wheel well is incorrectly moved and twisted.
A. 机身上有三个顶升点。
B. 机体上有三个基准点。
C. 机腹上有三个插孔。
A. In these conditions, removal of the squibs from the fire extinguisher bottle is appropriate.
B. It is dangerous to remove the cartridges from the fire extinguisher bottle except under these conditions.
C. In these conditions, it is dangerous to remove the cartridges from the fire extinguisher bottle.
A. If the two indications do not agree, do the test again.
B. If there is a conflict between the two indications, repeat the test.
C. If the two indicators show any conflict, repeat the test.
A. The manufacturer may establish procedures to provide drawback on unairworthy conditions.
B. The manufacturer may establish procedures to provide response on unairworthy conditions.
C. The manufacturer may establish procedures to provide recall on unairworthy conditions.
A. It is important that the correct sequence of assembly is used when doing a repair, this will make sure that all parts are correctly aligned.
B. It is important to assemble the parts in a correct order during a repair which makes sure all parts correctly aligned.
C. When doing a repair, the correct sequence of assembly is important, which will make sure that all parts are correctly engaged.
A. 该控制组件安装在机身尾部。
B. 该控制组件安装在驾驶舱后部。
C. 该控制组件位置在驾驶舱底部。
A. If as many as 50% of the holes are contaminated, you should clean the display units behinds the holes.
B. The holes on the bottom of the display unit should be cleaned once over 50% of them are clogged due to contamination.
C. If contamination causes a blockage of more than 50 percent of the holes, then clean the holes on the rear of the display units.
