A、 The inlet door actuator is installed aft of the rear pressure bulkhead on the inner side of the air inlet door.
B、 The air inlet actuator is mounted on the side of the pressure bulkhead behind the intake valve.
C、 The air release actuator is located on top of the pressure bulkhead inside the intake valve.
答案：A
A、 The inlet door actuator is installed aft of the rear pressure bulkhead on the inner side of the air inlet door.
B、 The air inlet actuator is mounted on the side of the pressure bulkhead behind the intake valve.
C、 The air release actuator is located on top of the pressure bulkhead inside the intake valve.
答案：A
A. 机身上有三个顶升点。
B. 机体上有三个基准点。
C. 机腹上有三个插孔。
A. 给轮胎放气，释放所有氮气。
B. 将轮胎放平，释放轮胎内的氮气。
C. 让轮胎放气并充填氮气。
A. 所有人员必须充分了解安全预防措施。
B. 所有人员必须充分了解安全规定。
C. 所有人员必须充分了解逃生方法。
A. Make up for all gaps which are larger than 0.05 mm.
B. Repair all cracks that are wider than 0.05 mm.
C. Overhaul all fissures which are greater than 0.05mm.
A. Apply three layers of coating.
B. Apply three layers of primer.
C. Apply three layers of bottom primer.
A. Do not open the container if you are instructed that high pressure is dangerous.
B. If it states on the container that the pressure inside is high, do not open it.
C. If the instructions give a warning about dangerous pressure, do not open the container.
A. 衡量硅酸吸收水分需要的时间。
B. 测量硅胶吸收水分所需的时间。
C. 计算硅钢片浇注成形的时间。
A. 确保L和R PACK开关在P5-10空调面板上显示OFF位。
B. 确保P5-10空调面板上的L和R PACK开关处于OFF位置。
C. 确保P5-10面板上的L和R PACK在OFF位时，空调按钮在关闭位。
A. 记录对蒙皮表面进行的所有修理。
B. 记录对蒙皮封严进行的所有修理。
C. 记录对蒙皮损伤进行的所有处理。
A. Explaining how to obtain the maximum ground miles per gallon through careful flight planning and attention to good operating procedures is the primary content.
B. Display how to achieve the main objective to get the greater ground miles per gallon by careful flight planning and attention to good operating procedures.
C. The principal purpose is to show how to increases the ground miles per gallon as much as possible with careful flight planning and attention to good operating procedures.
