Identify the cables with a code.

A. 如果可能，从技术文件中提供充分的示例来支持您的提议。

B. 如果可能，请从技术文档中提供有效的示例来支持您的措施。

C. 如果可能，将从技术文档中提供足够的示例来构建您的想法。

A. The equipment list shall include all needed or auxiliary equipment installed in the particular airplane when delivered.

B. All needed or optional equipment installed in the particular airplane when transported shall be contained in the equipment list.

C. The equipment list shall contain all required or optional equipment installed in the particular airplane when delivered.

A. Ensure you switch off the brown VALVE CLOSED light next to each switch.

B. Make sure the amber VALVE CLOSED light below each switch goes off.

C. The purple VALVE CLOSED light under each switch is confirmed off.

A. Do not lift the aircraft on jacks if the wind speed is more than 20 MPH.

B. Do not hoist the aircraft on chocks if the wind speed is more than 20 MPH.

C. Do not raise the aircraft on jacks if the wind speed is more than 20 km/h.

A. There are three jacks onboard the fuselage.

B. There are three jacking adapters on the fuselage.

C. There are three jacking points on the fuselage.

A. If you drink contaminated water , illness must happen.

B. You may be in trouble, if you drink bacteria free water.

C. If you drink water that contains bacteria, you will get sick.

A. The forward movement of the control lever must be slow and continuous.

B. The control lever must be kept moving forward slowly and abruptly.

C. You must continuously slow down the forward movement of the control lever .

A. When you access to the rear fuselage through the access panel.

B. When you get to the aft aircraft body through the control panel.

C. As you reach to the aft part of the aircraft by the visit door.

A. The APU fire alarm system accumulates the same fire alarm in the flight deck as in the engine.

B. The APU fire warning system actuates the same fire warning in the flight compartment as the engines.

C. The APU fire warning system activates the same fire warning in the cockpit as for the engines.

A. Clamps should be spaced at intervals not exceeding 24 inches. Clamps on wire bundles should be selected so that they have a snug fit without pinching wires.

B. Pins should be spaced at intervals not exceeding 24 inches. Pins on harness should be selected so that they have a snug fit without pinching wires.

C. Pins should be spaced at intervals not exceeding 24 inches. Pins on harness should be selected so that they have a snug fit without scratching wires.