A、 涂料足够柔软,用塑料铲子将其去除。
B、 涂料足够柔软,用塑料楔子将其去除。
C、 涂料足够柔软,用胶铲子将其去除。
答案:A
A、 涂料足够柔软,用塑料铲子将其去除。
B、 涂料足够柔软,用塑料楔子将其去除。
C、 涂料足够柔软,用胶铲子将其去除。
答案:A
A. Review the failures report from the logbook and related fault messages with center DU or CDU, debrief the flight crew for faults and report them for handling.
B. Either the logbook or center DU/CDU shall be checked for faults records and related fault information, then review the faults reported by the flight crew and take actions.
C. Consult the failures report from the logbook to find the related information on center DU or CDU, listen to the crew for faults report. Report faults and handle them.
A. 它包括传感、计算、作动、指示和警告装置,例如计算机、伺服器、作动器、警告灯等。
B. 它包括感知、计算、激活、指示和警告装置,例如计算机、伺服机构、激活器、警告灯等。
C. 它包括感知、处理、启动、指示和告诫装置,例如处理器、作动机构、起动机、告诫灯等。
A. 确认减速板能够立即收回。
B. 确保速度刹车立即缩回。
C. 确保减速制动器立即断开。
A. To gain entry to the nearby structure, take out the sensor.
B. Remove the sensor to get access to the adjacent structure.
C. Disassemble the sensor to get access to the adjacent structure.
A. 安装活门和正确的垫圈。
B. 安装阀门和对应的封圈。
C. 安装接头和相应的垫片。
A. If a word is only understood by a very small number of people in a specific technical area, it will cause interference in communication.
B. If a word is only understood by a very small number of people in a specific technical area, it will cause disturbing in negotiations..
C. If a word is only understood by a very small number of people in a special skill area, it will cause interference in communication.
A. Procedures contain tasks that give instructions on how to perform them.
B. Procedures contain general instructions that show you how to do tasks.
C. Procedures contain instructions that tell you how to do a task.
A. Stringers and the upper wing skin are called vent channels. The vent channels go through drain float valves in the center tank.
B. Stringers and the upper wing skin are compose of the vent channels. The vent channels got exhaust float valves from the center tank.
C. Stringers and the upper wing skin make the vent channels. The vent channels have drain float valves in the center tank.
A. 当必须理解原理图时,最好使用箭头来画出流动方向。
B. 当需要理解原理图时,应该使用箭头来指示流动方向。
C. 当需要理解计划表时,应该使用线条来指示流动方向。
A. Visual difference is acceptable between the previous surface and the new surface.
B. There should be no visual difference between the initial surface finish and the new surface finish.
C. It is forbidden to have acoustic difference between the former surface finish and the new surface finish.