A、 作动时间必须在28至40秒之间,在某个方向作动电流不得超过0.5安培。
B、 指令要求作动时间必须在28至40秒之间,且作动电流不得少于0.5安培。
C、 在任何一个方向上作动的时间必须在28至40秒之间,且作动电流不得超过0.5安培。
答案:C
A、 作动时间必须在28至40秒之间,在某个方向作动电流不得超过0.5安培。
B、 指令要求作动时间必须在28至40秒之间,且作动电流不得少于0.5安培。
C、 在任何一个方向上作动的时间必须在28至40秒之间,且作动电流不得超过0.5安培。
答案:C
A. The cover contains manufacturer's information and will be subject to its discretion.
B. The cover is determined by the manufacturer and the information should be comprehensive.
C. The information to be included on the cover will be left to the manufacturer's discretion.
A. ATA chapter is indicated by a pair of the digits of the first fault code.
B. ATA chapter is indicated by latest pair of the digits of the fault code.
C. The first pair of the digits of fault code indicates the applicable ATA chapter.
A. 一个关于序列号/组件号(或其他识别信息)的列表在右边页面相应的栏目中。
B. 页面右侧相应的栏目中列出了对应的序列号/组件号(或其他识别信息)。
C. 一组对应序列号/组件号(或其他识别信息)的栏目应显示在正确的页面上。
A. Make sure that the coils of the oxygen hose do not rub together.
B. It is acceptable the coils of the chlorine hose rub together.
C. Ensure that the coils of the nitrogen hose do not rub together.
A. Several screws pulled out in front of right wing fuselage fairing.
B. Several screws lost in front of right wing fuselage fairing.
C. Forward of right wing body fairing has several loose screws.
A. 曲线半径必须至少为8mm。
B. 圆的直径必须最小为8mm。
C. 曲线的直径必须最大为8mm。
A. 温度越高,融解的速度越快。
B. 湿度越大,水分蒸发越慢。
C. 温度越高,蒸发的速度越快。
A. The connector has 32 contacting points.
B. The contact has 32 contactors.
C. The contactor has 32 contacts.
A. 应使用比例尺图对飞机的总体布局进行说明,该比例尺图由平面图、侧视图和正面视图组成,并在单页上以垂直顺序展示。
B. 应使用气动布局图对飞机总体安排进行说明,说明内容包括计划、侧面图和正面图,并以垂直顺序在单页上列出。
C. 应在单页上以横向顺序的呈现方式对飞机总体布局和示意图进行说明,包括平面图、侧视图和正面视图。
A. Find appropriate torque values in the table above.
B. Refer to the table that follows for the applicable torque values.
C. Proper torque values can be found in the booklet attached.