A、 Additional information may follow the check list to make the check list easier for the pilots to understand it.
B、 The additional information should be followed by the pilots to make better understanding the check list.
C、 The additional information is followed the check list, to make the pilots better understanding the check list the pilots should read it in sequence.
答案:A
A、 Additional information may follow the check list to make the check list easier for the pilots to understand it.
B、 The additional information should be followed by the pilots to make better understanding the check list.
C、 The additional information is followed the check list, to make the pilots better understanding the check list the pilots should read it in sequence.
答案:A
A. Ground Control depicts minimum diameter of turning for taxiing and ground operation.
B. Ground Control describes minimum radius of turn for taxiing and ground handling.
C. The least radius of turn for taxiing and ground maneuver is described in Ground Control.
A. NOTE: The manufacturer may have the option of including wiring schematic in Chapter 24, Chapter 91, or establish a separate Wiring Diagram Manual.
B. NOTE: The manufacturer may have the option of including wiring schematic in Chapter 24, Chapter 91, or establish a separate Wiring Schematic Manual.
C. NOTE: The manufacturer may have the option of including wiring diagrams in Chapter 24, Chapter 91, or establish a separate Wiring Diagram Manual.
A. 特殊尺寸应显示在图形中。
B. 详细尺寸应显示在图纸上。
C. 主要尺寸应显示在图纸上。
A. When you try to change a word, make sure that the substitute you choose doesn't replace the meaning of the sentence.
B. Make sure that the chosen replacement word will not vary the implication of the sentence if you replace a word.
C. When you replace a word, always make sure that the alternative you select does not change the meaning of the sentence.
A. Set the air conditioning switch to the up position.
B. Place an air conditioning switch above the normal position.
C. Put one of the pack switches in the HIGH position.
A. Perform an external zonal inspection of the lower fuselage.
B. Inspect the outer area of the lowest fuselage.
C. Do the exterior medial check of the fuselage .
A. The values must be less than the approved differences.
B. The values must not exceed the allowable differences.
C. The values must be less than the allowable differences.
A. Definitions in this manual shall be conformed with those in the Federal Aviation Legislations.
B. Definitions in the handbook shall be consistent with definitions contained in the Federal Aviation Regulations.
C. Definitions in the Federal Aviation Regulations shall be consistent with definitions contained in the handbook.
A. The system is pneumatically operated and mechanically controlled.
B. Hydraulic power drives the system, while electricity is connected.
C. The system is hydraulically operated and electrically controlled.
A. The engine sump and gearboxes are connected internally.
B. There are also internal connections between the engine sumps and gearboxes.
C. Internal arrangement of wires exist between the engine sump and gearboxes.