A、 当需要了解膜片时,使用箭头指示方向。
B、 必要时应使用箭头表示流向来理解原理图。
C、 利用箭头指示的方向来理解线路施工图。
答案:B
A、 当需要了解膜片时,使用箭头指示方向。
B、 必要时应使用箭头表示流向来理解原理图。
C、 利用箭头指示的方向来理解线路施工图。
答案:B
A. 检查叶片是否有裂纹。
B. 检查刀片是否有擦伤。
C. 检查叶片是否出现凹坑。
A. Only representatives from ASD can join the group.
B. Representatives from countries that are not members of ASD are hardly to take part in the group.
C. Both representatives from ASD and from countries that are not members of ASD can join the group.
A. 通气油箱排放单向活门允许通气油箱内的燃油流到1号或2号主油箱。
B. 通气油箱排放检查活门使通气油箱内的燃油流动于1号和2号油箱之间。
C. 通气油箱排放单向活门使通气油箱内的燃油流入1号及2号主油箱。
A. 允许的最大差值为5mm。
B. 最小容差为5mm。
C. 允许的平均偏差为5mm.
A. “禁止踩踏”区域或可通往翼、身油箱的路线必须表记出来并加以必要的警示信息。在有些飞机上,用黑色点带标示出“禁止踩踏”区域。英文或双语标记的位置使得从前面或后面靠近飞机时都可以读到这些标记。
B. “没有台阶”区域或不可通往翼、身油箱的路线必须表记出来并加以必要的警示信息。在有些飞机上,用黑色点带标示出“没有台阶”区域。英文或双语标记的位置使得从前面或后面靠近飞机时都可以读到这些标记。
C. “禁止踩踏”区域或不可通往翼、身油箱的路线必须表记出来并加以必要的警示信息。在有些飞机上,用黑色点带标示出“禁止踩踏”区域。英文或双语标记的位置使得从前面或后面靠近飞机时都可以读到这些标记。
A. 随之,会导致电子和电气设备和系统的永久失效或超温。
B. 因此,会导致电子和电气设备和系统的临时或永久失效。
C. 此后,会导致电子和电气设备的临时或永久功能衰退。
A. 检查后再次拉长连杆。
B. 测试后再次移动连杆。
C. 检查后再次调节连杆。
A. Use the upper latch mechanism to lock the lower display unit in the middle.
B. The latch mechanism at the top is used to secure the center display unit on the bottom.
C. The center lower display unit is installed with the latch mechanism at the top.
A. 饮用水系统是系统中用于储存新鲜饮用水和洗涤用水的那部分。
B. 饮用水系统是系统中用于储存和输送新鲜饮用水的那部分。
C. 饮用水系统是系统中用于输送新鲜饮用水和废水的那部分。
A. Turn the drain valve counterclockwise to cause the fluid to stop flowing before the valve is pushed.
B. When you turn the drain valve counterclockwise, no fluid will flow until you push the valve in.
C. Make sure there is no fluid flowing after the valve is pushed, then turn the drain valve clockwise.