A、 Lubricate the engine and its accessories with the same brand.
B、 Lubricants for the engine and the auxiliary equipment are the same.
C、 The engine and the additional devices are greased in a same manner.
答案:B
A、 Lubricate the engine and its accessories with the same brand.
B、 Lubricants for the engine and the auxiliary equipment are the same.
C、 The engine and the additional devices are greased in a same manner.
答案:B
A. 较小的损坏可以不修理。
B. 更小的损坏不具备修理条件。
C. 一个稍小得损坏允许不带有修理方案。
A. 饮用水系统是系统中用于储存新鲜饮用水和洗涤用水的那部分。
B. 饮用水系统是系统中用于储存和输送新鲜饮用水的那部分。
C. 饮用水系统是系统中用于输送新鲜饮用水和废水的那部分。
A. Operation time should be recorded if the pump is in emergency .
B. When you use the emergency pump, record the time of operation.
C. When the pump is for emergency use, record the time of usage.
A. 货舱里有地板和衬层。衬层防止货舱内出现烟雾,防止对衬层和导线造成损坏。
B. 货舱里有地板和衬层。衬层使烟雾留在货舱,防止对衬层和导线造成损坏。
C. 货舱里有地板和衬层。衬层使烟雾留在货舱,防止对管路和导线造成损坏。
A. 通过最少两个全循环操作副翼,并操作至其最大行程。
B. 至少完整操作副翼两个全循环至其最大行程。
C. 操作副翼最小两个单位,至其最大行程。
A. If a symbol or device is established for a valve or control, it shall be used for this type of unit throughout the manual. The symbols used should be shown and identified in a legend block on the schematic diagram.
B. If a symbol or device has been set up to a valve or control, the equipment type will be referred to as this symbol or device throughout the manual. The legend block in the diagram displays or identifies symbols or device.
C. If a symbol or design is specified for a valve or control, this type of device is used throughout the section of the manual. The symbols used can be found and identified in the legend block of the schematic.
A. 从失速状态恢复期间,应增加超过100英尺的高度损失和低于地平线30度的俯仰角。
B. 应增加高度损失超过100英尺和俯仰操纵(低头)超过30度的失速改出数据。
C. 应增加从失速恢复过程中超过100英尺的高度损失和超过30度的地平面以下俯仰。
A. 发动机滑油携带这些微粒,直到它们被油滤捕获。
B. 直到颗粒被滤芯过滤,发动机滑油才能将它们带走。
C. 发动机滑油将这些污染物带至滑油滤芯。
A. 锁住保险丝时要小心,它会伤害你的眼睛。
B. 剪保险丝时要小心,它会伤害你的眼睛。
C. 锁住电线时要小心。它会对你的眼睛造成伤害。
A. 空调的分配系统用来引导和分配空气。包括设备架的冷却系统和送风机、进气口(飞机内部)、管路、进气口(飞机外部)、单向活门等部件。不包括在温度和压力控制部分的活门。
B. 空调的分配系统用来引导和分配空气。包括设备架的冷却系统和送风机、进气口(飞机外部)、管路、进气口(飞机内部)、单向活门等部件。不包括在温度和压力控制部分的活门。
C. 空调的分配系统用来诱导和分配空气。包括设备舱的冷却系统和送风机、进气口(飞机内部)、管路、进气口(飞机外部)、单向活门等部件。不包括在温度和压力控制部分的活门。