A、 The recommended fuel conservation procedures shall contain a caution, if useful, that the power settings recommended by the manufacturer must be used during the use period of new and newly overhauled engines.
B、 The recommended fuel conservation procedures shall contain a caution, if applicable, that the power settings recommended by the manufacturer must be used during the break-in period of new and newly overhauled engines.
C、 The receptable fuel conservation procedures shall contain a caution, if applicable, that the power settings recommended by the manufacturer must be used during the management period of new and newly overhauled engines.
答案：B
A、 The recommended fuel conservation procedures shall contain a caution, if useful, that the power settings recommended by the manufacturer must be used during the use period of new and newly overhauled engines.
B、 The recommended fuel conservation procedures shall contain a caution, if applicable, that the power settings recommended by the manufacturer must be used during the break-in period of new and newly overhauled engines.
C、 The receptable fuel conservation procedures shall contain a caution, if applicable, that the power settings recommended by the manufacturer must be used during the management period of new and newly overhauled engines.
答案：B
A. 检查时间将根据一些问题进行调整。
B. 针对严重问题将调整检查次数。
C. 针对严重问题将延长检查时间。
A. Move the sensor downstream and calculate the temperature again.
B. Move the probe downstream and monitor the temperature again.
C. Move the part downstream and measure the temperature again.
A. It supersedes the preceding edition.
B. It updates the previous version.
C. It takes place of the following version.
A. If as many as 50% of the holes are contaminated, you should clean the display units behinds the holes.
B. The holes on the bottom of the display unit should be cleaned once over 50% of them are clogged due to contamination.
C. If contamination causes a blockage of more than 50 percent of the holes, then clean the holes on the rear of the display units.
A. 当座舱无气流时则可能出现波动。
B. 无气流输送至舱内则有窒息的危险。
C. 因为有窒息的危险所以舱内未曾供气。
A. 测量压力下降所需时间。
B. 必须测量压力下降时间。
C. 压力下降所需时间是可以测量的。
A. 在这些条件下，机械和电子螺距修剪系统将无法工作。
B. 在这些状况下，机构和电气横滚调整系统将不能运转。
C. 在这些情况下，机械和电气俯仰配平系统将不能工作。
A. When describing the airplane＇s Landing Gear, how its indication system functions shall be explained.
B. When describing the airplane＇s Landing Gear, how its emergency response system functions shall be explained.
C. In the description of the airplane＇s Landing Gear, how its warning system functions shall be explained.
A. In an emergency, you can use fuel F-43 as an alternative to fuels F-34 and F-40.
B. In an emergency, you can replace fuels F-43 with fuels F-34 and F-40.
C. In an emergency, fuel F-43 can be used as an alternate to fuels F-34 and F-40.
A. After 10 flight cycles or 25 flight hours, which comes first, the rod end bearing shall be discarded if its wear is greater than 0.010 inch of diameter.
B. If the rod end bearing wear is greater than 0.010 inch in radial play, reject it within next 10 flight cycles or 25 flight hours whichever comes first.
C. Destroy the rod end bearing during 10 flight cycles or 25 flight hours when its wear is more than 0.010 inch of its radius, whichever comes first.
