A、 After three full cycles, extend and retract the actuator.
B、 You should extend and retract the actuator through three complete cycles.
C、 Do nothing to the actuator after three complete cycles.
答案：B
A、 After three full cycles, extend and retract the actuator.
B、 You should extend and retract the actuator through three complete cycles.
C、 Do nothing to the actuator after three complete cycles.
答案：B
A. The routing of the cable loom may have been altered by the installation.
B. The routing of the cable loom may have been held by the installation.
C. The routing of the cable loom may have been defended by the installation.
A. The computer needs to be backup at each interval.
B. The backup of the computer is necessary.
C. Back up your computer regularly.
A. This procedure gives you the disassembly process.
B. You can find the procedures for disassembling in this section.
C. The assembly process can be found in this section.
解析：这道题是关于给出组件拆卸程序的部分。选项A说这个程序给出了拆卸过程，选项C说装配过程可以在这个部分找到，而选项B说你可以在这个部分找到拆卸的程序。正确答案是B。
想象一下，当你购买一台新的电子设备时，通常会附带一个使用手册。在这个手册中，会详细说明如何拆卸和组装设备。这些步骤通常会在一个特定的部分中列出，让用户可以轻松找到。所以，选项B是正确的，因为在这个部分你可以找到拆卸的程序。
A. Move the IDG forward and outboard until it is away from the accessory gearbox, QAD ring and power plant.
B. Move the IDG towards the forward position until the input shaft is away from the accessary gearbox and QAD ring, then move the IDG towards outboard and free of the power plant.
C. After moving the IDG towards the forward position, then it is free of the accessary gearbox, QAD and the power plant.
A. You can use the module to disassemble the disassembly fixture.
B. The module that you can use to disassemble is the disassembly fixture.
C. You can use the disassembly fixture to disassemble the module.
A. Make sure the drain hose＇s open end is oriented in align with the structure.
B. Direct the open end of the drain hose away from the storage construction.
C. Ensure that the open end of the drain hose faces away from the structure.
A. In the event of filler bonding to the tool, dip the tool in cold water.
B. If the filler bonds to the tool, avoid using water to moisten the tool.
C. If the filler sticks to the tool, make the tool wet by applying cold water.
A. Use the marks on the bellcrank and shaft to identify them and prevent incorrect installation.
B. Mark the bellcrank and shaft so that they＇ll be identified and incorrect installation will not occur.
C. Put marks on the bellcrank and shaft or incorrect installation will occur.
A. The center of gravity moves along with the weight of the wings.
B. The center of gravity moves in relation to forces applied on the wings.
C. The center of gravity moves evenly to the loads of the wings.
A. Put sealant around each screw hole.
B. Seal each screw hole.
C. Put each screw hole into sealant.
