A、 The exit doors are mainly used for passenger boarding.
B、 The exit doors are only used for evacuation.
C、 The exit doors are not only used for the passengers to evacuate from the airplane but also used for normal exit.
答案：B
A、 The exit doors are mainly used for passenger boarding.
B、 The exit doors are only used for evacuation.
C、 The exit doors are not only used for the passengers to evacuate from the airplane but also used for normal exit.
答案：B
A. Check such system to determine the cause of interference.
B. Examine part of the system to find the cause of the interference.
C. Examine all of the system to find the cause of the interference.
A. In the event of filler bonding to the tool, dip the tool in cold water.
B. If the filler bonds to the tool, avoid using water to moisten the tool.
C. If the filler sticks to the tool, make the tool wet by applying cold water.
A. Check all parts with clear defects in accordance with standard industry practices.
B. Check all parts for visible defects in accordance with standard industry practices.
C. Check all parts for serious defects in accordance with standard industry practices.
A. Move the IDG forward and outboard until it is away from the accessory gearbox, QAD ring and power plant.
B. Move the IDG towards the forward position until the input shaft is away from the accessary gearbox and QAD ring, then move the IDG towards outboard and free of the power plant.
C. After moving the IDG towards the forward position, then it is free of the accessary gearbox, QAD and the power plant.
A. Soak the element for two hours.
B. Wet the element for two hours.
C. Stove the element for two hours.
A. Pilots have more opportunity to move stabilizer to nose up position during takeoff thanks to the mach trim actuator who commands elevator to a more nose down position.
B. During takeoff, pilots have more opportunity to move elevator to nose up position thanks to the mach trim actuator who commands stabilizer to a more nose down position.
C. During takeoff, pilots have more opportunity to move elevator to nose down position thanks to the mach trim actuator who commands stabilizer to a more nose up position.
A. Clean the surface with a soap and clean a water solution.
B. Use a soap-and-water solution to clean the surface.
C. Use a soap to clean the surface and a water solution.
A. It is not recommended that we remove the damage prior to submitting information to Boeing,such as dents on metallic and composite structures, and delamination or punctures to composite structure.
B. If the removal of dents on metallic and composite structures, and delamination or punctures to composite structure is approved by SRM,CMM,or SB,it is preferable to remove the damage prior to submitting information to Boeing.
C. It is recommended that we remove the damage prior to submitting information to Boeing,such as dents on metallic and composite structures, and delamination or punctures to composite structure.
A. If the lamp is too weak, charge the battery.
B. If the light is too strong, do a replacement of the battery.
C. If the light is not bright, the battery should be replaced.
A. The flap angles can not be found in Table 1.
B. The flap angles are stated in Table 1.
C. In Table 1, there are no flap angles.
