Dry the surface with a towel.

A. If you want to use the STE specification properly, a high professional standard is required.

B. A high level of professionalism requires the correct use of STE specifications.

C. In order to use the STE specifications appropriately, high professionalism is needed.

A. Adjust the lever intentionally and reset the system to the neutral position.

B. Move the lever before setting the system to the neutral position again.

C. In case of an inadvertent lever movement, return the system to the neutral position again.

A. Mark and protect the parts and then remove the parts.

B. Mark and protect the parts that are removed.

C. Mark and protect the parts that will be removed.

A. This Section shall be clearly stated and cross-referenced to the proper paragraph in Section 2 of the Handbook which consists of limitations.

B. This Section contains limitations which shall be clearly stated and cross-referenced to the proper paragraph in Section 2 of the Handbook.

C. The proper paragraph in Section 2 of the Handbook shall describe and cross-reference this Section included in this limitations.

A. The color of the bottom mark on the plate is amber.

B. You can see the red bottom mark on the board.

C. There is no color of the bottom mark on the board.

A. In order to set the configuration and operate the system, the operator uses an external joystick and control panel.

B. An external joystick and control panel is used to make the configuration and operate the system.

C. To operate an external joystick and control panel for the configuration and the system operation.

A. The accuracy of the adjustment can vary.

B. The accuracy of the adjustment can be fixed.

C. The precision of the adjustment can be prevented .

A. An "Airplane Weighing Form" shall be included in each handbook and the form shall contain an airplane side view that shows the location of weighing points (using jacking points or landing gear) relative to the datum line.

B. Each handbook shall provide an aircraft side view that is included in an "Airplane Weighing Form" to show the position of weighing points (using jacking points or landing gear) related to the datum line.

C. An airplane three view that shows the weighing points ((using jacking points or undercarriage) relative to the datum line shall be excluded in an "Airplane Weighing Form" of each handbook.

A. Only the certified personnel can complete the modification or repair to the aircraft.

B. Pay attention that inspections or maintenance work ought to be carried out by mechanics.

C. Modifications or repairs to aircraft should be achieved by releasing staff.

A. The air pressure is almost correct.

B. The air pressure is too low.

C. The air pressure is too high.