Refer to the table that follows for the applicable torque values.

A. Clean the elastic surfaces that are transparent.

B. Clean the plastic surfaces that are not transparent.

C. Clean the plastic surfaces that are not vague.

A. In some cases, wires are color coded and these should be shown on the wiring diagram.

B. In some cases, wires are color coded and these should be installed on the wiring diagram.

C. In some cases, wires are color coded and these should be explained on the wiring diagram.

A. Do a thorough check of the hydraulic system.

B. Do a check of the hydraulic system carefully.

C. Do a check of the hydraulic system again.

A. Even though this specification is conformed to recognized industry practices , it is prepared in broad genuine terms and it is recognized that problems will occur which are not handled enough by the specification.

B. Although this specification coheres with recognized industry practices , it is written in vast general terms and it is asserted that problems will appear which are not treated sufficiently by the specification.

C. Though this specification complies with accepted industry practice, it is compiled in wide generic terms and it is recognized that problems which are not treated adequately by the specification will arise.

A. Rub the basin with water.

B. Flush the basin with water.

C. Fill the basin with water.

A. Use the correct tools to open the containers for these materials.If you do not follow these prerequisites, injury to your skin and lungs can occur.

B. Get the corrective tools to open the containers for these materials.If you do not obey these precautions, injury to your skin and lungs can occur.

C. Get the proper tools to open the containers for these materials.If you do not observe these precautions, injury to your skin and lungs can occur.

A. Use the specified one if the equivalent material is not available.

B. Use the available equivalent one if no material is specified.

C. If you can not get the specified material, use an equivalent.

A. Without venting the IDG, the accuracy of your check will be affected.

B. Only if you reset the IDG, your check is effective.

C. The ventilation of the IDG accelerates your check.

A. Notes emphasize conditions such as operating procedures, inspection, repair or maintenance, etc., which may be met as appropriate.

B. Notes emphasize the conditions of operation procedure, inspection, repair or maintenance, etc., must be followed.

C. Conditions for operating procedures, inspection, repair or maintenance, etc. must be emphasized in the notes.

A. Sometimes, FAA and other airworthiness authority may accept the Continuing Airworthiness Program that uses the Specification.

B. Sometimes, we use the Specification to prepare a Continuing Airworthiness Program that will be accepted by non-FAA airworthiness authority.

C. Sometimes, during preparing a Continuing Airworthiness Program, using the Specification may be accepted by FAA and other airworthiness authority.