Refer to Table 7001 for information about how the pivot assembly is made.

A. Inspect the drain holes for obstruction.

B. Check for the drain holes for abrasion.

C. Check the drain holes for leakage.

A. Schematic diagram designers may make a compromise so as to add more details to make the diagram self-explanatory and keep its simplicity at the same time for ease of reading and understanding.

B. In designing schematic diagrams, it may be necessary to pay attention to both detail that is necessary to make the diagram self-explanatory, and simplicity that is essential for ease of reading and understanding.

C. Detail makes the diagram self-explanatory. Simplicity makes it easy to read and understand. It is necessary to consider both of them and make a compromise if needed when designing schematic diagrams.

A. If the lamp is too weak, charge the battery.

B. If the light is too strong, do a replacement of the battery.

C. If the light is not bright, the battery should be replaced.

A. The CAP compiler should determine the format and layout, it is desirable that the format and layout should be similar to the compiler＇s current documents.

B. The format and layout should be determined by the CAP producer, it is intended that the format and layout shall be similar to the producer＇s existing files.

C. The format and layout should be determined by the CAP producer, recognized that it is desirable the format and layout should be the same as the producer＇s existing documentaries.

A. It is the responsibility of the operator to ensure that alternative tools or equipment can work well and are dangerous to the parts and personnel as the ones specified in the procedure if you use them.

B. If alternative tools or equipment are used, the operator must ensure that they can play the same role and are as safe as the tools or equipment specified in the procedure to the parts and personnel.

C. If the manufacturer can make sure that alternative tools or equipment can meet the requirement and are as safe to the parts and equipment as the ones specified in the procedure, you can use them.

A. When the cumulative revised pages (including back-up pages) exceeds 60% of the total pages of the manual, a reissue should be prepared.

B. If the updated pages, including back-up pages, were less than 60% of the total page of the manual, a new manual should be copied.

C. Up to 60% of total pages (including back-up pages) were accumulated by mistake, the manual should be rewritten.

A. When some new kind of situation occurs, the operator should communicate openly with the manufacturer. The manufacturer should supply the operator solid assistance.

B. When the new situation gets worse, it should build the open communication between the operator and manufacturer. The operator claims the situation to get the feedback from the manufacturer.

C. When something new happens, open interconnection should exist between the manufacturer and the operator. The operator should report to the manufacturer to obtain effective discount.

A. Apparently, the Supplement about the subject system or equipment, if installed, must be in the Pilot＇s Operating Handbook whenever applicable.

B. You shall know clearly that when the subject system or equipment is installed, the Pilot＇s Operating Handbook must always contain the related Supplement.

C. When the subject system or equipment is installed, you need to clearly identify the associated Supplement in the Pilot＇s Operating Handbook at all times.

A. In some cases, wires are color coded and these should be shown on the wiring diagram.

B. In some cases, wires are color coded and these should be installed on the wiring diagram.

C. In some cases, wires are color coded and these should be explained on the wiring diagram.

A. Describe how to operate the safety belt and wire harnesses.

B. Tell the way to use the seat and shoulder belts.

C. The seat and shoulder harness should be used by the pilot.