A、 This Section shall be clearly stated and cross-referenced to the proper paragraph in Section 2 of the Handbook which consists of limitations.
B、 This Section contains limitations which shall be clearly stated and cross-referenced to the proper paragraph in Section 2 of the Handbook.
C、 The proper paragraph in Section 2 of the Handbook shall describe and cross-reference this Section included in this limitations.
答案:B
A、 This Section shall be clearly stated and cross-referenced to the proper paragraph in Section 2 of the Handbook which consists of limitations.
B、 This Section contains limitations which shall be clearly stated and cross-referenced to the proper paragraph in Section 2 of the Handbook.
C、 The proper paragraph in Section 2 of the Handbook shall describe and cross-reference this Section included in this limitations.
答案:B
A. Put the bell crank and shaft with identification to prevent improper installation.
B. Identify the bell crank and shaft with marks to prevent wrong installation.
C. Put the bell crank and shaft with identification to prevent wrong installation.
A. At the location shown in the figure, waterproof corrosion inhibiting compound has been used on certain aircraft construction. To keep the effectiveness of this protection, reapply the compound in these or other locations periodically.
B. Water displaying corrosion inhibiting compound has applied on certain airplanes structure in the locations in this figure. Periodic reapplication must be applied in these and other locations, so as to maintain effectiveness of this protection.
C. Water displacing anti-seize compound has been applied on certain airplanes construction in the locations in this figure. Periodic reapplication should be utilized in these and other locations, in order to keep effectiveness of the protection.
A. Manufacturer determines specific range properly to describe sophisticated and professional information. The information can be put in Maintenance Maunal or other documents.
B. Detailed information on more intricate and specific subjects can be written in two ways: Maintenance Manual or individual documents. The two ways are dependent on manufacturer's option properly.
C. It is up to the manufacturer to decide where and to what extent to include detailed information about more sophisticated and professional topics, either in the common Maintenance Manual or in another new documents.
A. Handbooks shall be ready to revise in accordance with the specification.
B. In accordance with the specification, manuals should be easy to revise.
C. Handbooks have been already revised, according to the specification.
A. This Section shall be clearly stated and cross-referenced to the proper paragraph in Section 2 of the Handbook which consists of limitations.
B. This Section contains limitations which shall be clearly stated and cross-referenced to the proper paragraph in Section 2 of the Handbook.
C. The proper paragraph in Section 2 of the Handbook shall describe and cross-reference this Section included in this limitations.
A. Adjust the lever intentionally and reset the system to the neutral position.
B. Move the lever before setting the system to the neutral position again.
C. In case of an inadvertent lever movement, return the system to the neutral position again.
A. The responsibility of ABC is not to modify the airplanes that belong to STC.
B. It is not STC's responsibility to modify ABC's aircraft.
C. ABC is not in charge of the aircraft modified by STC.
A. Apparently, the Supplement about the subject system or equipment, if installed, must be in the Pilot's Operating Handbook whenever applicable.
B. You shall know clearly that when the subject system or equipment is installed, the Pilot's Operating Handbook must always contain the related Supplement.
C. When the subject system or equipment is installed, you need to clearly identify the associated Supplement in the Pilot's Operating Handbook at all times.
A. Uncontrolled system or old equipment cause hydraulic fluid flow from hydraulic system A to B.
B. If you fail to operate the system control properly or the equipment is damaged, the hydraulic fluid will be transferred between hydraulic system A and B.
C. Flow of hydraulic fluid between hydraulic system A and B result in accidental operation of system controls or damaged equipment.
A. The parts must be assembled tightly.
B. Make sure that the parts are attached securely.
C. The parts must be assembled loosely.