A、 Restrictions on use of cabin pressurization during Takeoff, landing, or in flight shall be noted
B、 That portion of the system is used to de-ice all airfoil surfaces once ice is formed.
C、 All airfoil surfaces are equipped with that portion of the system to stop ice formation.
答案：C
A、 Restrictions on use of cabin pressurization during Takeoff, landing, or in flight shall be noted
B、 That portion of the system is used to de-ice all airfoil surfaces once ice is formed.
C、 All airfoil surfaces are equipped with that portion of the system to stop ice formation.
答案：C
A. It＇s not easy to install more than two washers for each bolt.
B. It is forbidden to install more than two washers for each bolt.
C. Installing one washer for each bolt is forbidden.
A. Notes emphasize conditions such as operating procedures, inspection, repair or maintenance, etc., which may be met as appropriate.
B. Notes emphasize the conditions of operation procedure, inspection, repair or maintenance, etc., must be followed.
C. Conditions for operating procedures, inspection, repair or maintenance, etc. must be emphasized in the notes.
A. The compressing of the spring can cause the valve to open.
B. There is no change of the valve when the spring compresses.
C. After compressing of the spring, the valve goes to closed position.
A. Evaluate the impedance between the antenna baseplate and the airplane skin.
B. Record the measured resistance between the antenna baseplate and the airplane skin.
C. Perform the measurement of the resistance between the antenna baseplate and the airplane skin.
A. This example shows that we were only allowed to calculate the data applicable to a Type B unit.
B. The data we are now calculating in this example apply only to Type B unit.
C. The data used for the calculations in this example apply only to a Type B unit.
A. The schematic diagrams need to list a lot of instructions, so the items listed are ordered according to certain rules, this is the order in which the items are placed on the plane.
B. There are schematics which need to list a lot of items, so the items listed should be sorted according to certain rules, such as the order in which the items are placed on the plane.
C. List a large number of schematics in logical order, such as the position of the items on the plane.
A. Remove the test cap between the Precooler Control Valve and the 3908 sensor on the control pressure sense line and ensure that there is air flowing out of the port.
B. From precooler control valve to 3908 sensor, remove the sense line test cap, make certain that the air flows from the test hub.
C. The purpose of the test cap removal from the Precooler Control Valve to the 3908 sensor is to guarantee that there is airflow at the test port.
A. In order to obtain additional clearance, gaskets may be added.
B. Additional shims may need to be added to obtain proper clearance.
C. Add special shims as necessary may vary the clearance.
A. One or more separate documents for some types of equipment such as avionics and instrumentation may be required because they change frequently or they have various combinations.
B. Some types of equipment such as avionics and instrumentation are changed regularly or combined in different forms, requiring to have one or more separate documents.
C. Some types of equipment such as avionics and instrumentation are often revised or combined differently to require one or more separate documents.
A. Explaining how to obtain the maximum ground miles per gallon through careful flight planning and attention to good operating procedures is the primary content.
B. Display how to achieve the main objective to get the greater ground miles per gallon by careful flight planning and attention to good operating procedures.
C. The principal purpose is to show how to increases the ground miles per gallon as much as possible with careful flight planning and attention to good operating procedures.
