130.The minimum time between checks is two minutes.

A. If you find metal particles in the reservoir,find their source and repair the broken part.

B. If you find metal particles in the pump,find their source and repair the defective part.

C. If you find material particles in the pump,find their source and repair the damaged part.

A. During inspection,if the nuts and washers are removed,recheck them.

B. Take a good place for the nuts and washers removed during inspection.

C. If nuts and washers are removed during inspection,install the new ones.

A. Correct operation of the parts does not allow dents to occur.

B. Dents that have an influence on the correct operation of the parts are not allowed.

C. Dents can prevent correct operation of the parts,so they are not permitted.

A. Filling with oxygen is not permitted during defueling and refueling.

B. Servicing with oxygen is not allowed during refueling and defueling.

C. Servicing with oxygen is not prohibited during fueling and defueling.

A. Many electrical power components are in the EE compartment.

B. Many electrical power components are in the cargo compartment.

C. Many electrical power components are in the APU compartment.

A. 出于标记的简单性,这些调整片分隔器应该被放大。

B. 为便于参阅,这些隔页签应交错排列。

C. 为引用方便,这些调整片分配器应该被储存好。

A. 应提供描述可能出现的故障、如何识别这些故障以及这些故障的补救措施的故障排除信息。

B. 提供的排故信息应描述可能出现的故障、如何识别相关故障以及相应的补救措施。

C. 应提供描述可能出现的故障、如何识别这些故障以及补救措施的排除信息。

D. C.应提供描述可能出现的故障、如何识别这些故障以及补救措施的排除信息。

A. Propellers must be overhauled in a satisfactory shop which should be supplied by the propeller manufacturer in accordance with data.

B. Overhaul of propellers and the shop must meet the data of the propeller manufacturer.

C. Overhaul of propellers must be accomplished in a qualified shop in accordance with data supplied by the propeller manufacturer.

A. Too much force can cause damage to the sealing components.

B. Excessive force may damage the seal.

C. Too much force can cause damage to the contact surface.

A. The specification is designed to cut off the cost to general aviation airplane owners and operators and maintenance personnel.

B. The target of the specification is to reduce the cost of general aviation airplane owners and operators and maintenance personnel.

C. The objective of the specification is to minimize the cost to general aviation airplane owners and operators and maintenance personnel.