A、 There are trim tabs at the rear of both ailerons.
B、 There are trim tabs at the rear of both flaps.
C、 There are trimmable stabilizers at the rear of both elevators.
答案：A
A、 There are trim tabs at the rear of both ailerons.
B、 There are trim tabs at the rear of both flaps.
C、 There are trimmable stabilizers at the rear of both elevators.
答案：A
A. 在后面的盒子中,标题应为“机长操作手册”。
B. 后一种情况时,标题应为“飞行员操作手册”。
C. 后一种情况时,标题应为“机长操作手册”。
A. In such cases,the introduction should notice the systems related in the manual, manufacturers may also choose to group related systems where the simplicity of the product permits.
B. In such cases,the introduction should note the systems covered in the manual, manufacturers may also choose to group related systems where the simplicity of the product permits.
C. In such cases,the introduction should note the systems comprised in the manual, manufacturers may also choose to divide related systems if the product is simple enough.
A. When a capital letter or a symbol is used for a unit of measurement,you should take it and the number before it as a word.
B. When used in measurement,the acronym or the symbol and the related number should be taken as a word.
C. When you write an abbreviation or a symbol for a unit of measurement,count it and the preceding number as one word.
A. 根据 FAR 43 部的要求,持证飞行员可以拥有或驾驶载客飞机,并可以对其飞机实施限制范围内的预防维护。
B. 持有或驾驶航空器的持证飞行员由 FAR 43 部授权对其进行特定的预防维护。
C. 如果持证飞行员拥有或驾驶的飞机不用于航空承运目的,他可以按照 FAR 43 部授权,对飞机进行有限的预防性维护。
D. C.如果持证飞行员拥有或驾驶的飞机不用于航空承运目的,他可以按照 FAR 43 部授权,对飞机进行有限的预防性维护。
A. 数据应该被显示为仪表空速和指示空速来保证零误差。
B. 数据应作为标定空速呈现,而不是零机械误差的仪表空速。
C. 假定仪表误差为零,数据应以校正空速和指示空速显示。
A. Maximum Landing Weight is maximum weight supplied for the landing contact.
B. Minimum Landing Weight is minimum weight provided for the landing touchdown.
C. Maximum Landing Weight is maximum weight approved for the landing touchdown.
A. Obtain approval from the design authority after making any changes to this repair procedure.
B. Prior to modifying this repair procedure,obtain the approval of the design authority.
C. Ensure that the design authority approves nonessential alterations made to this repair procedure.
A. Contamination of the grease can cause damage to the bearing.
B. Contamination of the oil can cause damage to the shaft.
C. Pollution of the grease can cause damage to the axle.
A. 拆下故障部位后部的标签。
B. 排除故障后,拆下标签。
C. 出现故障后,拆下铆钉。
A. A centrifugal pump supplies hydraulic fluid to the unit.
B. The unit is isolated from hydraulic fluid through a centrifugal pump.
C. A centrifugal pump withdraws hydraulic fluid from the unit.
