A、 This step is applied to primer layer only.
B、 This step can be only applied when the top is painted.
C、 This step is applicable only when you apply the top layer of paint.
答案：C
A、 This step is applied to primer layer only.
B、 This step can be only applied when the top is painted.
C、 This step is applicable only when you apply the top layer of paint.
答案：C
A. 不同类别和型号的飞机在设计和复杂性上的差异对具体故障有很大影响。
B. 设计上的差异以及各种类型和型号的飞机的复杂性都对一个具体故障产生很大影响。
C. 各种类别和型号的飞机因设计不同导致其复杂性不同,飞机承担的主要功能也不同。
A. 紧急出口不用于日常进出,而用于紧急情况,包括结构件、闩锁机构、扶手、绝缘、内衬、操纵装置等物品。
B. 紧急出口是为方便疏散而设立的出口门,不用于日常进出,包括结构件、闩锁机构、扶手、绝缘材料、内衬、操纵装置等物品。
C. 应急出口通常不用作常规出口,包含诸如结构件、门闩、把手、隔热材料、衬板、控制器等。
D. B.紧急出口是为方便疏散而设立的出口门,不用于日常进出,包括结构件、闩锁机构、扶手、绝缘材料、内衬、操纵装置等物品。
E. C.应急出口通常不用作常规出口,包含诸如结构件、门闩、把手、隔热材料、衬板、控制器等。
A. The equipment refrigeration system exchanges the key equipment cabinets and the equipment in the compartment.
B. The equipment cooling system removes heat from the equipment in the main equipment center and the flight compartment.
C. The equipment exchange system removes heat from the lower equipment center and the aft cargo compartment.
A. If as many as 50% of the holes are contaminated,you should clean the display units behinds the holes.
B. The holes on the bottom of the display unit should be cleaned once over 50% of them are clogged due to contamination.
C. If contamination causes a blockage of more than 50 percent of the holes,then clean the holes on the rear of the display units.
A. Maximum altitude loss during stall recovery is approximately 800 feet.
B. Maximum altimeter loss during spin recovery is about 800 feet.
C. Maximum weight loss during stall recovery is nearly 800 feet.
A. 飞行控制系统指能够实现手动操纵飞机飞行姿态特性的部件和组件,包括液压增压系统、方向舵脚踏板、驾驶杆、控制钢索、调整片控制装置、安装支架等。
B. 飞行控制系统指控制飞机飞行姿态特性的手动部件和组件,包括液压增压系统、方向舵踏板、控制杆联接、控制电缆、襟翼控制、安装支架等。
C. 飞行控制系统指能够控制飞机飞行高度特性的手段,包括液压增压系统、舵踏板、控制杆联接、控制钢索、襟翼控制、安装支架等。
D. B.飞行控制系统指控制飞机飞行姿态特性的手动部件和组件,包括液压增压系统、方向舵踏板、控制杆联接、控制电缆、襟翼控制、安装支架等。
E. C.飞行控制系统指能够控制飞机飞行高度特性的手段,包括液压增压系统、舵踏板、控制杆联接、控制钢索、襟翼控制、安装支架等。
A. 在另一个人的启发下安装盖子。
B. 在另一个人的帮助下安装盖子。
C. 在另一个人的帮助下安装螺帽。
A. Elevator move is limited by the move of the elevator power control units.
B. Elevator trip is limited by the move of the elevator power control units.
C. Elevator travel is limited by the stroke of the elevator power control units.
A. This procedure is only for repairs that include a very small number of screws.
B. This procedure is only for repairs that include a very small number of nuts.
C. This procedure is only for repairs that include a very small number of rivets.
A. This Specification includes miscellaneous FAA regulations.
B. This Specification is involved in numerical FAA regulations.
C. This Specification refers to various FAA regulations.
