A、 Before restarting the engine,make sure to clear the ground from any fuel spills.
B、 Remove all spilled fuel from the ground before making the first attempt to start the engine.
C、 Ensure that no fuel on the ground is eliminated before proceeding with engine startup.
答案：A
A、 Before restarting the engine,make sure to clear the ground from any fuel spills.
B、 Remove all spilled fuel from the ground before making the first attempt to start the engine.
C、 Ensure that no fuel on the ground is eliminated before proceeding with engine startup.
答案：A
A. The maximum continuous power listed in the Airplane Type Data Sheet is used to show compliance with the applicable airworthiness standards and is the value shown in the Pilot's Operating Handbook.
B. The maximum continuous power listed in the Airplane Type certificate is often used to show compliance with the applicable airworthiness standards and is the value shown in the Pilot's Operating Handbook.
C. The maximum continuous power listed in the Airplane Type Data Sheet is used to show compliance with the applicable airworthiness regulations and is beyond the value shown in the Pilot's Operating Handbook.
A. 检查后再次拉长连杆。
B. 测试后再次移动连杆。
C. 检查后再次调节连杆。
A. If the microswitch becomes unserviceable,proceed with the actuator activation procedure to damage the valve.
B. When the microswitch is functional,ensure the deactivation procedure of the actuator is performed to avoid any harm to the valve.
C. If the microswitch malfunctions,execute the actuator deactivation procedure to protect the valve from harm.
A. This is the maximum portion of flammable vapors in air.If the portion is bigger,when an ignition source touched the gas,it would cause the fire to be diffused.
B. This is the minimum volume of flammable vapors.If the volume is lower,when the gas contacted with an ignition source,the fire would not come out.
C. This is the minimum density of flammable vapors in air.If the density was lower,when an ignition source touched the gas,it would not cause the spread of flame.
A. The purpose of radar is to obtain,process and display image information.
B. Grasping,processing and displaying grafic information is the function of radom.
C. The purpose of radar is to transmit,process and caculate image information.
A. If the scratch does not go through the protective layer,the unit is serviceable.
B. If the nick does not go through the primary surface,the unit is serviceable.
C. If the scratch does not go through the protective surface,the unit is movable.
A. 使用多余的清洁剂清洁该区域。
B. 清除该区域多余的密封胶。
C. 在该区域内清理有害的密封剂。
A. Find appropriate torque values in the table above.
B. Refer to the table that follows for the applicable torque values.
C. Proper torque values can be found in the booklet attached.
A. Scrap the unit at the next check.
B. Repeat the unit at the next check.
C. Change the unit when performing next check.
A. Drill the hole until it has a radius of 8.00 +/- 0.003 mm.
B. Ream the hole until it has a diameter of 8.00 +/- 0.003 mm.
C. Trim the hole until it has a width of 8.00 +/- 0.003 mm.
