1969.Describe each equipment list item and show its weight and airplane location,with respect to the datum.

A. Each wire is comprised by an alphabetical code following 2 alpha digits and 2 numerical digits.

B. Each wire is identified by an alphanumerical code comprising 2 alpha digits followed by 2 numerical digits.

C. Each wire consists of an alphanumerical code following 2 alpha digits and 2 numerical digits.

A. 安装前先润滑密封件。

B. 安装前先把润滑油进行密封。

C. 在设备前面密封润滑油。

A. 警告铃声和喇叭将开始响起,然后再次停止。

B. 警示铃声和喇叭将会停止启动,然后再次响起。

C. 先开启警告铃声和麦克风,然后再停止使用。

A. NOTE: The manufacturer may have the option of including wiring schematic in Chapter 24,Chapter 91,or establish a separate Wiring Diagram Manual.

B. NOTE: The manufacturer may have the option of including wiring schematic in Chapter 24,Chapter 91,or establish a separate Wiring Schematic Manual.

C. NOTE: The manufacturer may have the option of including wiring diagrams in Chapter 24,Chapter 91,or establish a separate Wiring Diagram Manual.

A. The equipment list shall include all needed or auxiliary equipment installed in the particular airplane when delivered.

B. All needed or optional equipment installed in the particular airplane when transported shall be contained in the equipment list.

C. The equipment list shall contain all required or optional equipment installed in the particular airplane when delivered.

A. The localizer beam is aligned with the centerline of the runway.

B. The localizer way is misaligned with the centerline of the runway.

C. The localizer course is aligned with the centerline of the runway.

A. Interior Labels and Signs are required for interior general and emergency information,instructions,cautions,warnings,etc.

B. Interior Placards and Markings are required for interior general and emergency information,instructions,cautions,warnings,etc..

C. Interior Placards and Signs are required for interior general and emergency information,instructions,warnings,cautions,etc.

A. The maximum distance between the plate edge and the frame is inferior to 0.05 mm.

B. The clearance between the boundary of the panel and the bay can not exceed 0.05 mm.

C. The distance between the edge of the panel and the partition must not be more than 0.05 mm.

A. Turn the handle of the door until the lower gate is lifted.

B. For lowering the upper door,door handle should be turned.

C. The lever of door should be turned until the lower door opens.

A. If the valve is the source of the fuel leak,discard the valve seals and install new ones.

B. If the fuel leaks out of the valve,reinstall the valve seals.

C. If the fuel leak flows towards the valve,discard the valve seals and install new ones.