A、 在本构型中,必须执行不同的测试程序。
B、 在本构型中,可以选用不同的测试程序。
C、 本次会议强制要求使用不同的测试程序。
答案:A
A、 在本构型中,必须执行不同的测试程序。
B、 在本构型中,可以选用不同的测试程序。
C、 本次会议强制要求使用不同的测试程序。
答案:A
A. 预估所需要的数量。
B. 估计必须的清洗液数量。
C. 估计所需要的消耗量。
A. 速度-高度纠错系统通过修正实际速度尽可能保持飞机安全飞行高度。
B. 通过修正实际速度尽可能保持飞机安全飞行高度的任务由速度-高度纠错系统完成。
C. 速度-姿态修正系统通过修正速度的影响,自动保持安全的飞行姿态。
A. The sequence of the explanation should be powerplant instrument markings,then powerplant limitations.
B. An explanation of powerplant instrument markings shall immediately follow the presentation on powerplant limitations.
C. Presentation on powerplant limitations shall come after the explanation of powerplant instrument markings.
A. Only number CAP pages that contain one chapter in sequence and identify the chapters.
B. Number the pages of CAPs containing only one section in sequence with section identification.
C. For the CAP pages that contain only a chapter in sequence,mark the chapters.
A. 作动时间必须在 28 至 40 秒之间,在某个方向作动电流不得超过 0.5 安培。
B. 指令要求作动时间必须在 28 至 40 秒之间,且作动电流不得少于 0.5 安培。
C. 在任何一个方向上作动的时间必须在 28 至 40 秒之间,且作动电流不得超过 0.5 安培。
A. 加油活门可以在前起落架减震支柱下部找到。
B. 充气活门位于前起落架减震支柱顶部。
C. 充气活门可以在前起落架顶部的减震支柱上面找到。
A. Find appropriate torque values in the table above.
B. Refer to the table that follows for the applicable torque values.
C. Proper torque values can be found in the booklet attached.
A. 数据应能够显示外界空气温度、高度、重量和风与着陆距离的关系。应包括地面滑跑和飞越 50 英尺障碍物的总距离。应给出为获得总距离所需的 50 英尺高度点上的速度。
B. 数据应显示为着陆距离与外部气温、高度、重量和风的关系。应包括地面滑跑和飞越 50英尺障碍物的总距离。应给出在 50 英尺高度点达到总距离的速度。
C. 数据应能够显示外界空气温度、高度、重量和风与着陆距离的关系。 应包括着陆滑跑距离和从离地 50 英尺到着陆完全停止所需的总着陆距离。应给出飞机飞抵 50 英尺高时的速度。
D. B.数据应显示为着陆距离与外部气温、高度、重量和风的关系。应包括地面滑跑和飞越 50英尺障碍物的总距离。应给出在 50 英尺高度点达到总距离的速度。
E. C.数据应能够显示外界空气温度、高度、重量和风与着陆距离的关系。 应包括着陆滑跑距离和从离地 50 英尺到着陆完全停止所需的总着陆距离。应给出飞机飞抵 50 英尺高时的速度。
A. Make sure that the cargo compartment pressure stays constant.
B. Make sure that there is pressure in the cabin.
C. Make sure that the cabin pressure stays constant.
A. Ensure you switch off the brown VALVE CLOSED light next to each switch.
B. Make sure the amber VALVE CLOSED light below each switch goes off.
C. The purple VALVE CLOSED light under each switch is confirmed off.