A、 If the wheel temperature reaches as high as 177 deg.,the core of safety plug shears off and the tire slips.
B、 If the wheel temperature increases to more than 177 deg.,the core of the fusible plug melts and the tire deflates.
C、 The core of the filter element melts once the wheel temperature is above 177 deg.,causing the tire to deflate.
答案：B
A、 If the wheel temperature reaches as high as 177 deg.,the core of safety plug shears off and the tire slips.
B、 If the wheel temperature increases to more than 177 deg.,the core of the fusible plug melts and the tire deflates.
C、 The core of the filter element melts once the wheel temperature is above 177 deg.,causing the tire to deflate.
答案：B
A. 确保气流不低于 10 升/分钟。
B. 确保空气流量为 10 升/分钟。
C. 确保气流不超过 10 升/分钟。
A. Maximum Limiting speed Unsticks is the speed restrain which will not be intentionally surpassed in typical flight operations.V is communicated in knots and M in Mach Number.
B. Maximum Restriction Speed is the fastest a plane can fly without breaking the rules in normal flight.The speed is measured in knots and Mach Number.
C. Maximum Operating Limit Speed is the speed limit that may not be deliberately exceeded in normal flight operations.V is expressed in knots and M in Mach Number.
A. 《飞行员操作手册》是 FAR 第 23 部规章的审定要求,通勤类飞机除外。
B. 《飞行员操作手册》对有 FAR 第 23 部规章审定基础的飞机是恰当的,通勤类除外。
C. 《飞行员操作手册》适用于通过 FAR 第 23 部规章审定的飞机,但通勤类飞机除外。
A. Ignore the absence of contamination in the fuel sample and continue with the procedure.
B. Continue with the procedure if the fuel sample does not exhibit any contamination.
C. Proceed with the procedure regardless of any contamination found in the fuel sample.
A. Substitutes with different quality can be used.
B. You can not use substitutes with same quantity.
C. Equivalent substitutes are permitted to use.
A. The gears will automatically engage if a malfunction occurs.
B. If there is proper functioning,the gears will automatically engage.
C. If there is a malfunction,the gears will automatically disengage.
A. 检查油管,对于磨损的区域。
B. 磨削管道并检查。
C. 检查管道是否磨损。
A. Drill the hole until it has a radius of 8.00 +/- 0.003 mm.
B. Ream the hole until it has a diameter of 8.00 +/- 0.003 mm.
C. Trim the hole until it has a width of 8.00 +/- 0.003 mm.
A. When described the aircraft and its system,you should always use third people talking.
B. Generally,in describing the airplane or its system,third person wording should be used.
C. When you describing the airplane systems,third person mood shall be used.
A. Lubricate the elevator tab hinges.
B. Lubricant the elevator tab links.
C. Grease the aileron tab hinges.
