A、 除重量和平衡舱单外,制造商还可提供用于计算重量和平衡的装置,并提供使用说明。
B、 除重量平衡装载表外,制造商还可提供重量平衡的计算设备,并提供使用说明。
C、 制造商可提供用于计算配重和配平的装置,来补充配重和配平装载表,并提供使用说明。
答案：A
A、 除重量和平衡舱单外,制造商还可提供用于计算重量和平衡的装置,并提供使用说明。
B、 除重量平衡装载表外,制造商还可提供重量平衡的计算设备,并提供使用说明。
C、 制造商可提供用于计算配重和配平的装置,来补充配重和配平装载表,并提供使用说明。
答案：A
A. Propellers must be overhauled in a satisfactory shop which should be supplied by the propeller manufacturer in accordance with data.
B. Overhaul of propellers and the shop must meet the data of the propeller manufacturer.
C. Overhaul of propellers must be accomplished in a qualified shop in accordance with data supplied by the propeller manufacturer.
A. Apply fuel to the steel surfaces.
B. Apply oil to the alloy surfaces.
C. Apply oil to the steel surfaces.
A. 将这些部分按概率顺序列在每个故障下面。
B. 根据可能的指令在每个问题中列出这些部分。
C. 将这些部分在潜在订单的问题中列举出来。
A. 如果一种化合物用于紧固件,使用“润滑紧固件”力矩。
B. 如果下列某一种化合物要用在紧固件上,则力矩需参考“润滑紧固件”。
C. 如果下列化合物之一用在紧固件上,则需使用“经润滑的紧固件”扭矩值。
A. 保留勤务部件,更换那些损坏的。
B. 报废损坏的部件后,保留所有可用的。
C. 保留所有可用的部件,报废那些损坏的。
A. Use a solution of foam and water to clean.
B. Clean with bleach and water.
C. Clean with a solution of soap and water.
A. If the error is more than 3 degrees,calibrate the glide slope.
B. If the error is more than 3 degrees,calibrate the compass.
C. If the error is more than 3 degrees,calibrate the gyroscope.
A. Before drill the hole,make sure that the point of the drill head is sharp.
B. Prior to drill the hole,make sure that the point of the drill bit is sharp.
C. Before you make the hole,make sure that the point of the drill bit is sharp.
A. If the clearance dimension is not accurate,adjust the clearance dimension between the extend proximity sensor [44A] and the target [45].Some of the ducts in the air distribution system are wrapped with insulation material.
B. Adjust the clearance dimension between the extend proximity sensor [44A] and the target [45] in case of the clearance dimension is out of tolerance.Some of the ducts in the air distribution system are wrapped with non-conductive material .
C. Adjust the clearance dimension between the extend proximity sensor [44A] and the target [45] until the clearance dimension is out of range.Some of the ducts in the air distribution system are wrapped with compound material.
A. 区分电路的相关部分。
B. 隔离电路的故障部分。
C. 断开电路的失效成分。
