2306.TIT Gauge is a temperature measuring system that senses gas temperature in the turbine section of the engine.

A. Do not install 0.1 mm thick shims.

B. Do not install shims which are more than 0.1 deep.

C. Do not install shims that are more than 0.1 mm thick.

A. Exterior Placards and Markings are required for ground servicing instructions,inspections,cautions,warnings.

B. Exterior Labels and Markings are required for ground servicing instructions,inspections,cautions,warnings.

C. Exterior Placards and Markings are required for ground servicing instructions,inspections,warnings,cautions.

A. Your skin and lungs can be protected.

B. Your skin and lungs can be harmed.

C. Your skin and lungs can be harmed suddenly.

A. You can calibrate all the compass systems at the same time.

B. You can fix all the compass systems at the same time.

C. You can calibrate all the magnetic needle systems at the same time.

A. Operational Test: That procedure required to ascertain only that a system or unit is operable.These tests should require no special equipment or facilities other than that are installed on the aircraft and should be comparable to the tests performed by the flight crew.It is not intended that theoperational test of the unit shall meet the specifications and tolerances ordinarily established for overhaul,or major maintenance periods."

B. Operational Test: That procedure required to ascertain only that a system or unit is operable.These tests should require no special equipment or facilities other than that are installed on the aircraft and should be comparable to the tests performed by the flight crew.It is not intended that the operational test of the unit shall meet the specifications and errors ordinarily established for overhaul,or significant maintenance periods."

C. Operational Test: That procedure required to ascertain only that a system or unit is operable.These tests should require no special equipment or facilities other than that are installed on the aircraft and should be comparable to the tests performed by the flight crew.It is not intended that the operational test of the unit shall meet the specifications and tolerances ordinarily established for overhaul,or significant maintenance periods.

A. Remove the 3 screws from the flap of the motor assembly.

B. Remove the 3 nuts from the flange of the motor assembly.

C. Remove the 3 screws from the flange of the motor assembly.

A. During the retraction test,keep a close watch on the monitor.

B. Continuously observe the indications after the retraction test.

C. Monitor the indications during the retraction test.

A. This configuration has three rest data for all the inertial and air data functions.

B. This configuration has triple redundant data for all the inertial and air data functions.

C. This configuration has three rest data for all the interface and air data functions.

A. 维修这个组件需要校准过的工具。

B. 安装这个组件需要专用工具。

C. 组件的安装需要精确的工具。

A. 双面打印除线路图和折页外的所有页。

B. 双面打印除线路图外的的所有折页。

C. 除了折叠的线路图外,双面打印所有页面。