A、 That portion of the system is used to perform the cranking portion of the starting operation.
B、 That portion of the system is used to perform the igniting portion of the starting operation.
C、 That portion of the system is used to perform the cranking portion of the igniting operation.
答案：A
A、 That portion of the system is used to perform the cranking portion of the starting operation.
B、 That portion of the system is used to perform the igniting portion of the starting operation.
C、 That portion of the system is used to perform the cranking portion of the igniting operation.
答案：A
A. 拆卸保留的封严。
B. 移动残留的防渗漏剂。
C. 清除剩余的密封胶。
A. Find appropriate torque values in the table above.
B. Refer to the table that follows for the applicable torque values.
C. Proper torque values can be found in the booklet attached.
A. 安装此组件需要专用工具。
B. 对于安装此组件来说批准的工具是必须的。
C. 专业工具对安装此组件是无所谓的。
A. 飞行控制系统指能够实现手动操纵飞机飞行姿态特性的部件和组件,包括液压增压系统、方向舵脚踏板、驾驶杆、控制钢索、调整片控制装置、安装支架等。
B. 飞行控制系统指控制飞机飞行姿态特性的手动部件和组件,包括液压增压系统、方向舵踏板、控制杆联接、控制电缆、襟翼控制、安装支架等。
C. 飞行控制系统指能够控制飞机飞行高度特性的手段,包括液压增压系统、舵踏板、控制杆联接、控制钢索、襟翼控制、安装支架等。
D. B.飞行控制系统指控制飞机飞行姿态特性的手动部件和组件,包括液压增压系统、方向舵踏板、控制杆联接、控制电缆、襟翼控制、安装支架等。
E. C.飞行控制系统指能够控制飞机飞行高度特性的手段,包括液压增压系统、舵踏板、控制杆联接、控制钢索、襟翼控制、安装支架等。
A. Illustrations should be used when they will simplify,shorten or make the text easier to understand.
B. When illustrations can simple,shorten or make the text easy for understanding,they may be used.
C. Whenever diagrams can simple,shorten or make the content easy to understand,they could be used.
A. 不要组装或修理点火嘴。
B. 不要拆解或修理点火嘴。
C. 不要组装或更换点火嘴。
A. If liquid spills in the kitchen,all traces of the liquid must be cleaned promptly and the concerned area must be completely dry.
B. If liquids are spilled inside the galley,you must remove all signs of liquid and fully dry the areas of contamination immediately.
C. If liquid spills in the galley,all marks of the liquid must be removed at once and the polluted area must be completely dried.
A. Check the defect before you start the procedure again.
B. Rectify the defect before you start the procedure again.
C. Define the defect before you start the procedure again.
A. The operator reassembled the linkage.
B. The operator adjusted the cable.
C. The operator adjusted the linkage.
A. 小心确认管路尽可能靠近探头支架的面板而不要碰到探头。
B. 小心确认接头尽可能靠近面板的天线支架而不要碰到天线。
C. 小心确认探头尽可能靠近面板的天线支架而不要碰到天线。
