A、 The vendor can build programs to supply response to worthless conditions found in compliance with regulations.
B、 The manufacturer may establish procedures to provide feedback on unairworthy conditions that were discovered when complying.
C、 The manufacturer may create a process to give feedback on abnormal conditions when it's conformed.
答案：B
A、 The vendor can build programs to supply response to worthless conditions found in compliance with regulations.
B、 The manufacturer may establish procedures to provide feedback on unairworthy conditions that were discovered when complying.
C、 The manufacturer may create a process to give feedback on abnormal conditions when it's conformed.
答案：B
A. 保留部分未达到满意粘合度的密封。
B. 丢弃所有粘合效果达标的密封件。
C. 丢弃所有黏合不好的密封件。
A. Do not use verbs that are general and vague.
B. Do not use verbs that are normal and mixed.
C. Do not use verbs that are usual and blended..
A. According to Boeing Docs and associated ADs,changing the dimension of the thrust reverser upper locking actuator lock sensor target can result in slow detection of the failure or undetected failure.
B. Based on the Boeing Docs and the associated ADs,if the size of the thrust reverser upper locking actuator lock sensor target is increased,it may result in delayed or undetected the actuator failure.
C. As described in Boeing Docs and the associated ADs,if the orientation of the locking actuator on the thrust reverser locking sensor target changes,the actuator failure will be delayed or undetected.
A. 显示器必须与表中的数值一致。
B. 根据显示要求必须与台架上的活门保持相同。
C. 显示结果必须与表中的数值一致。
A. Other format is not permitted.
B. It's not permissible to use this form.
C. Either format is allowed.
A. 螺柱的凹陷不得超过 5mm。
B. 螺柱的突起不得超过 5mm。
C. 螺纹的长度不得超过 5mm。
A. 如果一种化合物用于紧固件,使用“润滑紧固件”力矩。
B. 如果下列某一种化合物要用在紧固件上,则力矩需参考“润滑紧固件”。
C. 如果下列化合物之一用在紧固件上,则需使用“经润滑的紧固件”扭矩值。
A. If the values occur again,remove the unit.
B. If the symptoms occur again,remove the unit.
C. Remove the unit,until the symptoms occur again.
A. An alphanumeric identifier is an assembly of characters and numbers.It can recognize something.
B. An symbolic-numeric identifier is an assembly of symbols and numbers.It can identifies something.
C. An alphanumeric identifier is a combination of letters and numbers that identifies something.
A. Turn the cap counterclockwise.
B. Turn the cap clockwise.
C. Rotate the cap clockwise.
