This shows that you can install an alternative relay.

A. RESET测试电门用于减少故障历史。当VERFIY(通过)和绿色GO灯亮时, 按下RESET(复位)电门。

B. RESET测试电门用于转移故障记录。当VERFIY(验证)和绿色GO灯打开时, 按下RESET(复位)电门。

C. RESET测试电门用于消除故障记录。当VERFIY(确认)和绿色GO灯亮时, 按下RESET(复位)电门。

A. 如燃油面涨到通气油箱高度, 则燃油将从通风口中排出。

B. 如燃油水平在通气油箱有充足高度, 则燃油将从通风扇中排出。

C. 如燃油油位在通气油箱中足够高, 则燃油将从通风戽中排出。

A. 任何以ATA No.100格式发布的技术数据将满足本规范的要求，尽管预期在没有ATA-100要求的情况下将使用第19段格式。

B. 任何以ATA No. 100格式发布的技术数据将满足本规范的要求，但在没有预见ATA-100要求的情况下，将使用第19段格式。

C. 任何以ATA No. 100格式发布的技术数据将满足本规范的要求，但在预见不需要满足ATA-100要求的情况下，将使用第19段格式。

A. The General Aviation Manufacturers Association compiled this specification to guide the manufacturers of the aircraft ,engine and component developing their Continuous Airworthiness Program Inspection Documents.

B. The Continuous Airworthiness Program Inspection Documents prepared by the manufacturers of the aircraft ,engine and component was guided by the General Aviation Manufacturers Association.

C. This specification was developed by the General Aviation Manufacturers Association as guidance for airplanes, engine and component manufacturers in preparing Continuing Airworthiness Program Inspection Documents .

A. If the airplane has not been tested for twirl characteristics and recovery methods, a discussion shall be included on the limited conditions for preventing spins and the possible best recovery techniques, and it shall be stated that no testing has been conducted and that the recovery techniques are based on the manufacturer＇s best comment.

B. If the airplane has not been tested for spin characteristics and recovery methods, a discussion of prevention of spins and probable best recovery techniques will be included with a notation that no tests were made and the recovery techniques are based on the best judgment of the manufacturer.

C. If the aircraft has not been expanded for spin features and recovery ways, prevention of spin and possible best recovery techniques are discussed and it is determined that no exams have been performed and that recovery techniques are based on the manufacturer＇s best judgment.

A. 在此过程中，使用12英寸螺刀手柄。

B. 在此过程中，使用12英尺扳手手柄。

C. 在此过程中，使用12英寸扳手手柄。

A. In order to correctly connect the parts together, you have to put weight on the panel surface.

B. Apply weight on the surface of the patch to make sure that the parts bond correctly.

C. To make sure the parts are engaged properly, you should pressurize the plate surface.

A. 转矩表是指显示传动轴上可用的输出转矩的指示系统。扭矩可能显示为维度的尺寸，例如英尺-磅，或者参考定义，用百分比或压力值表示。

B. 扭矩表是指显示传动轴上可输出的扭矩指示系统。扭矩可以用尺寸来表示，如英尺-磅，也可以用百分数或压力等参考术语表示。

C. 扭矩表显示传动轴可以输出的扭矩指示系统。扭矩可以用尺寸表示，如英尺-磅，或是用百分数、压力等参考术语表示。

A. 发动机系统包含元件和部件用于控制和改变润滑剂在发动机入口和出口的流动。

B. 发动机系统包含控制和引导润滑油从进口流向出口的组件和部件。

C. 润滑剂靠发动机的元件和部件的控制和引导在发动机里产生流动。

A. Survey the opening for fractures that often avoid inspection.

B. Inspect the opening for cracks that originate from its corners.

C. Inspect the opening for blemish that often covers its corners.