This system shows the pilot the deviations from the localizer course and the glideslope path.

A. This Specification includes miscellaneous FAA regulations.

B. This Specification is involved in numerical FAA regulations.

C. This Specification refers to various FAA regulations.

A. 第11和12页的图1是53章、54章、55章和57章中规定的典型镀层/表皮图。

B. 第11和12页中的图1是53章、54章、55章和57章中典型的镀层/蒙皮插图。

C. 第11和12页的图1是系53章、54章、55章和57章中规定的典型电镀法/表皮图。

A. During antenna installation, disregard the direction the alignment arrow is pointing.

B. Align the antenna in the opposite direction in consideration of the alignment arrow in installation.

C. When installing the antenna, make sure the alignment arrow is directed towards the front.

A. 确保设备测量值与燃油箱的实际油量一致。

B. 确保表显数值与油箱加油量一致。

C. 确保仪表指示与油箱油量一致。

A. 为了使句子简短不要增加太多名词。

B. 为了使句子简短不要忽略名词。

C. 不要为了使句子简短而省略名词。

A. Ensure that no other repairs are underway in the repair area before undertaking this procedure.

B. This procedure can only be done if there are other repairs in the repair area.

C. Only proceed with this procedure if there are concurrent repairs being carried out in the designated repair area.

A. Find appropriate torque values in the table above.

B. Refer to the table that follows for the applicable torque values.

C. Proper torque values can be found in the booklet attached.

A. In designing schematic diagrams, it may be necessary to combine two aspects: specification necessary to make the diagram clear; And the similarity essential for ease of reading and understanding.

B. In designing schematic diagrams, it may be necessary to comprehend two aspects: detection necessary to make the diagram self-contained; And the simplification essential for ease of reading and understanding.

C. In designing schematic diagrams, it may be necessary to compromise two aspects: detail necessary to make the diagram self-explanatory; And the simplicity essential for ease of reading and understanding.

A. Do the weighing procedure in this sequence.

B. In this order to perform the swapping procedure.

C. In this sequence to do the analysis procedure.

A. Turn the canopy manually clockwise to make the pin removal process easier.

B. To make pin removal easier, manually turn the canopy in one direction and then in the other.

C. Rotate the canopy in one direction and then in the other to hinder the removal of the pin.