Repair the surfaces that have scratches.

A. Words with lowercase letters are allowed in STE.

B. STE dictionary is permitted to use the UPPERCASE letter word.

C. In STE, a word in capital letters means that it is approved.

A. When you lift the aircraft on racks, keep the center of the aircraft between these limits.

B. When you lift the aircraft on jacks, keep the center of gravity between these limits.

C. When you lift the aircraft on jacks, the gravity of the aircraft shall be limited.

A. 将这些部分按概率顺序列在每个故障下面。

B. 根据可能的指令在每个问题中列出这些部分。

C. 将这些部分在潜在订单的问题中列举出来。

A. All of the top vertical mounting struts are adjustable except the primary mount struts unless they are repaired or replaced. The spare vertical strut (left forward ) and the side strut (right forward) may require adjustment during APU replacement.

B. All of the vertical primary mount struts at the top are adjustable. However, adjustments to the primary mount struts are not required unless a strut is repaired or replaced. The redundant vertical strut (forward left) and the redundant side strut (forward

C. The top of every vertical main retaining struts is adjustable. However, adjusting the main mount strut is not allowed if the strut is not repaired or replaced. During APU replacement, it may be necessary to adjust remained vertical strut (left anterior) a

A. 如果你低下头去安装上阻力杆，在收起期间将撞击到下阻力杆。

B. 如果你顶部朝下地安装上阻力杆，在收起期间它将撞击到下阻力杆。

C. 如果你反向地安装上阻力杆，在放下期间它将撞击到下阻力杆。

A. 变更表格的发起者通常会得到STEMG评估和决定的相关通知。

B. 变更表格的发起人通常需要告知大家相关的STEMG评估和决定。

C. 变更表格的组织通常被告知相关的STEMG条款和决定。

A. This system does not include the usual channels of communication available to CAP.

B. This system does not supersede the normal channels of communication for items not covered by the CAP.

C. The usual channels of communication in this system cannot be replaced by the introduction of CAP.

A. Humidity adjustment is manual.

B. Pressure adjustment is automatic.

C. Temperature adjustment is automatic.

A. 不要使用金属制品，可能会割到或损坏上位锁弹簧表面。

B. 不要使用金属物件，可能会割到或损坏上位锁弹簧表面。

C. 不要使用金属制品，可能会划伤或损坏上位锁弹簧表面。

A. Make sure that the tab fully connects to the surface without bubbles.

B. Make sure that the label fully attaches to the surface and that there are no bubbles.

C. Make sure that the tag is fully engaged on the surface and no bubbles.