Carry out permanent repair by filling damaged area with potting compound BMS-287 with reference to SRM.

A. 控制升降舵/副翼和配平片位置和移动的系统部分。

B. 控制升降舵/升降翼和调整片位置和运动的系统部分。

C. 控制升降舵/升降副翼和配平片位置和移动的系统部分。

A. 在两个垫圈之间安装间隔装置。

B. 在两个清洗器之间安装垫片。

C. 在两个垫圈之间安装垫片。

A. 在每页的右下角输入页数和发行或改版日期。

B. 在每页的底部打印页码和发行或修订日期。

C. 在每页的底部输入页码和发行或修订数据。

A. When the temperature is below zero, depressurize the water system.

B. If the temperature drops below zero, deflate the water system.

C. If the temperature decreases to less than zero, drain the water system.

A. All of the top vertical mounting struts are adjustable except the primary mount struts unless they are repaired or replaced. The spare vertical strut (left forward ) and the side strut (right forward) may require adjustment during APU replacement.

B. All of the vertical primary mount struts at the top are adjustable. However, adjustments to the primary mount struts are not required unless a strut is repaired or replaced. The redundant vertical strut (forward left) and the redundant side strut (forward

C. The top of every vertical main retaining struts is adjustable. However, adjusting the main mount strut is not allowed if the strut is not repaired or replaced. During APU replacement, it may be necessary to adjust remained vertical strut (left anterior) a

A. This Handbook includes materials required to be provided to pilots under Federal Aviation Regulations, as well as additional information that to be provided by the manufacturer. These data are the bases for FAA to compile the airplane flight manual.

B. This Handbook includes materials that the manufacturer needs to provide to the pilot, as well as additional information required by the Federal Aviation Administration. Together, these data form the flight manual for FAA approved airplane.

C. This handbook includes the material required to be furnished to the pilot by the federal aviation regulations and additional information provided by the manufacturer and constitutes the FAA approved airplane flight manual.

A. Open the isolating valves.

B. Open the check valves.

C. Open the bypass valves.

A. Find appropriate torque values in the table above.

B. Refer to the table that follows for the applicable torque values.

C. Proper torque values can be found in the booklet attached.

A. Drill the hole until it has a radius of 8.00 +/- 0.003 mm.

B. Ream the hole until it has a diameter of 8.00 +/- 0.003 mm.

C. Trim the hole until it has a width of 8.00 +/- 0.003 mm.

A. 相对时间内的的生产效率就是相对生产率.

B. 速率是速度在一定时间的变化.

C. 加速度是速度随时间的变化率.