What is the position of APU bleed valve if the right engine is shut down?

A. The repair limits are not permitted as special equipment is required.

B. The repair limits are not mentioned as special equipment is required.

C. The repair limits are not set as special equipment is required.

A. 这些ALIs 是强制性的，未经负责飞机型号证书的FAA 办公室或适用的监管机构的批准，不能更改或删除。

B. 这些ALIs 是指令性的，未经FAA办公室批准不得更改或删除。FAA办公室负责飞机型号证书，或发布适用的管理规章。

C. 这些ALIs 是非常必要的，任何更改或删除必须获得FAA办公室批准，或者其他可以颁发飞机型号证书的监管机构的批准。

A. 空速可能提高操作安全，将做为一个正常程序的开头部分。

B. 可提高操作安全的空速应作为常规程序章节的前言给出。

C. 加强操作的安全可能需要改变空速，这种情况在正常程序的前言部分给出了。

A. If you find cracks, refer to the structural repair manual for damage classification and corrective action.

B. If you find the dents, according to the structural maintenance manual to get the damage group and take the correct action.

C. In the event of finding gaps, read the structural maintenance manual to sort the loss and correct the action.

A. The Handbook should refer to FAR Part 43 for list of things the pilot may do.

B. FAR Part 43 has a list of things the pilot may do.

C. FAR Part 43 recommends a manual that contains a list of things the pilot may do.

A. Too much force can cause damage to the sealing components.

B. Excessive force may damage the seal.

C. Too much force can cause damage to the contact surface.

A. The following components are recommended for alteration. The swap of other components can be made on condition.

B. The following parts are recommended to be refurbished. Other parts can be plated according to on wing status.

C. The following parts are recommended for modification. Utilization of other parts can be by in-service experience.

A. This software is only acceptable by the assigned handling system.

B. This software is compatible only with the specified operating system.

C. This software only corresponds to its designed operating system.

A. Make sure that the cargo compartment pressure stays constant.

B. Make sure that there is pressure in the cabin.

C. Make sure that the cabin pressure stays constant.

A. That portion of the system is used to indicate the quantity, temperature and pressure of the oil.

B. That portion of the system is used to indicate the quality, temperature and pressure of the oil.

C. That portion of the system is used to indicate the quantity, temperature and pressure of the fuel.