A、 如果由于腐蚀你不能拆卸螺栓,则涂渗透油。
B、 如果你不能去除螺栓的腐蚀,则申请穿透油。
C、 如果你由于防腐不能拆卸螺钉,则涂渗透油。
答案:A
A、 如果由于腐蚀你不能拆卸螺栓,则涂渗透油。
B、 如果你不能去除螺栓的腐蚀,则申请穿透油。
C、 如果你由于防腐不能拆卸螺钉,则涂渗透油。
答案:A
A. In a complicated system, troubleshooting is made up of four chapters.
B. Troubleshooting in a complex system consists of four sections.
C. Four processes are combined to troubleshoot the complicated system.
A. After 10 flight cycles or 25 flight hours, which comes first, the rod end bearing shall be discarded if its wear is greater than 0.010 inch of diameter.
B. If the rod end bearing wear is greater than 0.010 inch in radial play, reject it within next 10 flight cycles or 25 flight hours whichever comes first.
C. Destroy the rod end bearing during 10 flight cycles or 25 flight hours when its wear is more than 0.010 inch of its radius, whichever comes first.
A. 燃油温度传感器的电阻随燃油温度的变化而变化。
B. 燃油测温包的阻抗改变燃油的温度。
C. 电感改变燃油测温灯泡的燃油温度。
A. Set the tension indicator to zero.
B. Put the torque indication to zero.
C. Put the shear instrument to zero.
A. Misunderstanding will occur if a word is only understood by a large amount of people in a special technical area.
B. If a word is only known by quite a small amount of people in a special technical field, there will be communication interference.
C. If a word is only understood by a very small number of people in a specific technical area, it will cause interference in communication.
A. Find appropriate torque values in the table above.
B. Refer to the table that follows for the applicable torque values.
C. Proper torque values can be found in the booklet attached.
A. 在紧急情况下要无条件的服从乘务人员。
B. 在紧急情况下可以向乘务人员提出问题。
C. 在紧急情况不要向乘务人员提出问题。
A. The localizer beam is aligned with the centerline of the runway.
B. The localizer way is misaligned with the centerline of the runway.
C. The localizer course is aligned with the centerline of the runway.
A. Do not exceed this dimension or Mach in any operation.
B. Do not exceed the regulated flight speed or Mach Number in any operation.
C. Do not exceed this speed or Mach Number in any operation.
A. Operational Tags need to be listed or made a legend.
B. Operating Placards shall be listed or illustrated.
C. Operation Instructions have to be listed or mapped out.