To make the curing process slower, decrease the heat that you apply to the compound.

A. NOTE: The manufacturer may have the option of including wiring schematic in Chapter 24, Chapter 91, or establish a separate Wiring Diagram Manual.

B. NOTE: The manufacturer may have the option of including wiring schematic in Chapter 24, Chapter 91, or establish a separate Wiring Schematic Manual.

C. NOTE: The manufacturer may have the option of including wiring diagrams in Chapter 24, Chapter 91, or establish a separate Wiring Diagram Manual.

A. when the inspector asks, please show your license and obligations.

B. Please show your license and qualification authorization when asked by the inspector.

C. Please show your license and quality duties when asked by the inspector.

A. The following procedures will prevent deterioration of aircraft structural coatings or system components.

B. The procedures that follow will prevent the deterioration of the airplane structure, finish, or system components.

C. The delamination of the airplane structure, finish, or system parts will be blocked by the procedures listed below.

A. Landing gear is left for ten minutes.

B. Landing gear should be kept extended for ten minutes.

C. Extend landing gear after ten minutes＇ retraction.

A. Turn the drain valve counterclockwise to cause the fluid to stop flowing before the valve is pushed.

B. When you turn the drain valve counterclockwise, no fluid will flow until you push the valve in.

C. Make sure there is no fluid flowing after the valve is pushed, then turn the drain valve clockwise.

A. The test will stop when the pressure is larger than 7000 kpa.

B. Stop the test if the pressure reaches 7000 pa.

C. Stop the test when the pressure is more than 7000 kpa.

A. The computer consumes the energy based on these values calculations.

B. The computer calculates the energy consumption from these values.

C. The computer counts these values based on the energy costs.

A. Perform a test to identify the source of data transmission from the management unit.

B. Perform a test to determine if the management unit is transmitting the data.

C. Conduct a test to confirm that the management unit does not transmit the data.

A. 当飞机处于常态速度和巡航仰角时, 通气油箱内的燃油将排放到主燃油箱内。

B. 当飞机处于恒定速度和巡航俯仰角时, 通气油箱内的燃油将排放到主燃油箱内。

C. 当飞机处于超常速度和巡航俯仰时, 通气油箱内的燃油将排空到主燃油箱内。

A. 表1中列出的研磨剂是备选的，你可以选择使用。

B. 表1给出了可以使用的替代粘合剂。

C. 你只能使用表1中列出的等效粘合剂。