A、 Finish stage 1 to 4 to ensure that no axial force is derived from the rod.
B、 Do steps 1 thru 4 to make sure that no axial load is applied on the rod.
C、 Procedures 1 to 4 are designed to check if the rod exerts axial force.
答案：B
A、 Finish stage 1 to 4 to ensure that no axial force is derived from the rod.
B、 Do steps 1 thru 4 to make sure that no axial load is applied on the rod.
C、 Procedures 1 to 4 are designed to check if the rod exerts axial force.
答案：B
A. 不要使用其他未经批准的动词短语。
B. 不要使用其他未经批准的动词时态。
C. 不要使用其他未经批准的动词词组。
A. The following information on maneuvers appropriate to the Airplane Category shall be given: (a) A Statement of Authorized Maneuvers and Appropriate Entry Speeds (b) A Statement of Unauthorized Maneuvers (c) A Statement that the airplane is Approved for Spins, Unapproved for Spins, or is characteristically incapable of spinning.
B. The following information should be provided to the maneuver flight as appropriate: (a) A Statement of Entry Speed for Authorized Maneuvers (b) A Statement of Unauthorized Maneuvers (c) A Statement that aircraft is Unapproved or not suitable for Spinning.
C. The following appropriate information should be provided to the aircraft maneuvers: (a) A Statement of Appropriate Entry Speed for maneuvers flight (b) A Statement of Unauthorized maneuvers (c) A Statement that aircraft has been unapproved for Spins, or is characteristically incapable of spinning.
A. Put a plug on the open end of each pipe.
B. On the opening of each pipe, put a cover.
C. Put a cover on the loose end of the pipe.
A. Another important function of lubricating oil is to protect the corroded metal surfaces.
B. Another important task of the oil is to protect the metal surfaces from corrosion.
C. Preventing the metal surface from further corrosion is the other essential function of the lube.
A. Install the point tags on the negative overheat thermocouple of the turbine.
B. Install the terminal tags on the forward overheat thermocouple of the turbine.
C. Install the port tags on the rearward overheat thermocouple of the turbine.
A. To gain entry to the nearby structure, take out the sensor.
B. Remove the sensor to get access to the adjacent structure.
C. Disassemble the sensor to get access to the adjacent structure.
A. 本节应包含适当的警报或注意，以告知运营人员有责任确保遵守所有适航命令，并确保飞机的操作、服务和维修在需要时按照《联邦航空条例》进行。
B. 本节应以适当的警告或注意形式，提醒运营人确保遵守所有适航指令，确保按照《联邦航空规章》对飞机进行勤务、养护和维修。
C. 本节应包含适当的警告或注意事项，按照《联邦航空条例》，告知相关人员有责任遵守所有审批指令，确保必要时飞机的操纵、服务和修理可进行。
A. 用可用的方式计算压力。
B. 计算带可用公式的压力。
C. 用适用的公式计算压力。
A. Pilots have more opportunity to move stabilizer to nose up position during takeoff thanks to the mach trim actuator who commands elevator to a more nose down position.
B. During takeoff, pilots have more opportunity to move elevator to nose up position thanks to the mach trim actuator who commands stabilizer to a more nose down position.
C. During takeoff, pilots have more opportunity to move elevator to nose down position thanks to the mach trim actuator who commands stabilizer to a more nose up position.
A. Replace the No. 1 and No. 2 computers. Then do the test again.
B. Interchange the No. 1 and No. 2 computers. Then do the test again.
C. Repair the No. 1 and No. 2 computers. Then do the test again.
