The dictionary includes some unapproved words that can be technical names if you can put them in the applicable technical name category.

A. When describing the airplane＇s Engine, spark plug system shall be described.

B. When describing the airplane＇s Engine, starter system shall be described.

C. In the description of the airplane＇s Engine, ignition system shall be described.

A. A small amount of oil remains in the starter.

B. Little oil is stored in the starter.

C. The starter consumes a few oil.

A. Always keep the brightness control on the LCD display at maximum.

B. Always keep the brightness knob of the LCD monitor set to its maximum dimness position.

C. Always adjust the test knob of the LCD monitor set to maximum brightness position.

A. A servo system is a device that has the ability to carry out an order and give a response to fufill five basic requirements.

B. A servo system is a device that has the ability to carry out an order and give a response to orders. It can finish five basic requirements.

C. A servo system is a device that has the ability to respond to and carry out an order which must be able to fufill five basic requirements.

A. 描述飞机机翼襟翼、俯冲制动或扰流板系统时，应描述其应用如何影响俯仰姿态、空速、配平和失速速度。

B. 描述飞机机翼翼尖、俯冲制动或扰流板系统时，应描述其应用如何影响俯仰姿态、表速、配平和失速速度。

C. 描述飞机机翼襟翼、俯冲减速板或扰流板系统时，应描述各自工作时如何影响俯仰姿势、空速、配平和失速速度。

A. 拧紧松紧螺套，直到钢索达到合适的张力。

B. 松开再拧紧螺套，直到钢索有适当的张力。

C. 旋转螺套，确保钢索处于正确的位置。

A. 根据结构修理手册进行永久性修理，对损伤部位填充BMS-287填充剂。

B. 根据故障修理手册进行恢复性修理，对损伤部位填充BMS-287填充剂。

C. 根据勤务手册进行翻新修理，对损伤部位填充BMS-287填充剂。

A. The selection of data by manual producers which are included in this section shall be restrained by the concepts contained in the preface of this specification.

B. The selection of data by manual producers included in this section shall be governed by the concepts contained in the preamble to this specification.

C. In this selection, the producer＇s choice of data should be bound by concepts contained in the preamble of this specification.

A. 拆下标签。

B. 去除灰尘。

C. 移除设备。

A. Move it lightly and make it through the hole

B. Move it slightly to make it aim at the hole

C. Move it gently to make it enter the hole