A、 描述飞机打光系统时,应描述各种内部和外部打光系统。
B、 描述飞机灯光系统时,应描述飞机的各个内部和外部灯光系统。
C、 描述飞机灯光系统时,应描述各种向内和向外的应急灯光系统。
答案:B
A、 描述飞机打光系统时,应描述各种内部和外部打光系统。
B、 描述飞机灯光系统时,应描述飞机的各个内部和外部灯光系统。
C、 描述飞机灯光系统时,应描述各种向内和向外的应急灯光系统。
答案:B
A. Thus, whether the manual be a maintenance manual or a wiring diagram manual for a large airplane or a small airplane, the person wishing information concerning the indicating portion of the fuel system would refer to the Tab Chapter 28, Fuel.
B. Therefore, those hoping to obtain information about the fuel system instructions section of the repair manual or circuit diagram manual for both large and small aircraft may correspond to the label, chapter 28, Fuel.
C. As a result, regardless of the aircraft type (large or small), the person who wants to get display section information of the fuel system in the servicing manual or line diagram manual may search the tag, chapter 28, Fuel.
A. Be careful when you put your hand onto printed circuit boards.
B. Be careful when you get close to printed circuit boards.
C. Be careful when you remove printed circuit boards.
A. 衡量硅酸吸收水分需要的时间。
B. 测量硅胶吸收水分所需的时间。
C. 计算硅钢片浇注成形的时间。
A. To gain entry to the nearby structure, take out the sensor.
B. Remove the sensor to get access to the adjacent structure.
C. Disassemble the sensor to get access to the adjacent structure.
A. 当需要了解膜片时,使用箭头指示方向。
B. 必要时应使用箭头表示流向来理解原理图。
C. 利用箭头指示的方向来理解线路施工图。
A. If the rush air turbine has been extracted.
B. If the Ram Air Turbine (RAT) is retracted.
C. If the pushed air turbin has been extended.
A. 首先尝试安装有最短的螺纹区域的转接头。
B. 首先尝试安装带有最短螺纹的芯轴。
C. 首先尝试在最窄的区域内安装接头。
A. 给轮胎放气。
B. 给轮胎充气。
C. 给机轮充气。
A. The maximum distance between the plate edge and the frame is inferior to 0.05 mm.
B. The clearance between the boundary of the panel and the bay can not exceed 0.05 mm.
C. The distance between the edge of the panel and the partition must not be more than 0.05 mm.
A. 机身站位360处的地板梁有低度腐蚀(长2英寸,直径1英寸)。
B. 机身站位360处的地板梁有重度腐蚀(长2英寸,半径1英寸)。
C. 机身站位360处的地板梁有中度腐蚀(长2英寸,直径1英寸)。