Torquemeter displays the output torque available on the propeller shaft.

A. Do not put too much force on the brush when cleaning the carpet which can be easily damaged.

B. To prevent damage to the carpet when you clean it, do not use too much force on the brush.

C. Using too much force on the brush when cleaning the carpet will cause damage to it.

A. Send the results of the audit to the quality department.

B. Tell the quality department about the results of the analysis.

C. Let the quality department know the results of audit.

A. 根据制造商的意见，本章节描述飞机时提供了最有用的信息给最有可能驾驶飞机的飞行员。

B. 本章节将按照制造商考虑的方式描述飞机，以使最有可能操作该飞机的飞行员获得最多的信息。

C. 制造商考虑在本章节中描述飞机时提供更多的信息，以帮助飞行员更有效地操作飞机。

A. 把前侧或后侧座椅移动大约0.50英寸（12.70毫米）使座椅滑轨接头上的凸缘与座椅滑轨里的孔对齐。

B. 向前或后移动座椅大约0.50英寸（12.70毫米）使座椅滑轨接头上的凸缘与座椅滑轨里的孔对齐。

C. 把前侧或后侧座椅移动大约0.50英寸（12.70毫米）使座椅滑轨接头上与座椅滑轨里的孔对齐。

A. Hand tools can be divided to four basic categories: kicking tools, holding tools, cutting tools, bending tools.

B. Hand tools can be divided to four basic categories:kicking tools, clutching tools, cutting tools, rolling tools.

C. Hand tools will fall into four basic categories: pounding tools，holding tools， cutting tools and turning tools.

A. 参考修订FAR21.50的格式，应保持与使用的规范一致。

B. 修订应以FAR 21.50规定为基础，与其规范的格式一致。

C. 修订FAR 21.50规章的格式，应参考使用修订规范的格式要求。

A. This program describes how to identify an immediate failure and how to handle a malfunction occurred.

B. This procedure explains how to recognize impending problems and what to do if malfunctions occur.

C. How to confirm the current problems and what should you do when malfunctions occur are described in this procedure.

A. Make sure that the bolt heads are attached to the skin.

B. Make sure that the screw heads are connected with the metal.

C. Make sure that the fastener heads are flush with the skin.

A. Do a tire pressure check, and if necessary inflate the tires.

B. Check the pressure of a wheel and charge it if necessary.

C. Inspect the tire pressure and it＇s required to refuel.

A. Apply two kindreds of protective compound to shield the sealant from any harm caused by hydraulic fluid.

B. In order to prevent damage to the sealant from hydraulic fluid, it is necessary to apply two layers of protective compound.

C. To prevent hydraulic fluid from drowning the sealant, it is recommended to apply two layers of protective compound.