The precision of the gauges must agree with the applicable quality standard.

A. Refer to the general information in addition to engine operation limits, guidelines and special procedures.

B. For general information, refer to engine operation limits, guidelines and special procedures.

C. Refer to engine operation limits, guidelines and special procedures besides general information.

A. If you find cracks, refer to the structural repair manual for damage classification and corrective action.

B. If you find the dents, according to the structural maintenance manual to get the damage group and take the correct action.

C. In the event of finding gaps, read the structural maintenance manual to sort the loss and correct the action.

A. Apply weight on the surface of the patch to make sure that the parts bond correctly.

B. The parts can be aligned properly by applying force on the surface of the patch.

C. In order to correctly attach the parts, the patch surface should be compressed.

A. 标题页的背面应留白，以免需要改版，以及可能遗漏插入的飞机序列号和注册号。

B. 标题页的背面应保持空白，以备需要插入可能遗漏的飞机序列号和注册号。

C. 标题页的背面应有充分的内容，以免被插入遗漏的飞机序列号和注册号。

A. You may use alerts and cautions to emphasize some important places.

B. The important parts must be highlighted by using the warnings, cautions and notes.

C. Warnings, cautions and notes may be used to highlight or emphasize important points.

A. The temperature can be increased by decreasing the cure time.

B. Decreasing the cure time that can increase the temperature.

C. Increase the temperature to decrease the cure time.

A. The oil supply element and the three magnetic particle testing detectors are in the lubrication unit.

B. The oil supply filter and the three chip detectors are in the lubrication unit.

C. Position the oil supply filter assembly and the three magnetic chip detectors in the lubrication unit.

A. The power source that are discussed respectively under the appropriate chapter heading shall provide power to at least two systems.

B. When two or more systems are served by a single power source, that power source will be discussed separately under the appropriate chapter heading.

C. The system that is powered by two or more power sources shall be discussed separately under the appropriate chapter heading.

A. Do a hardness test for turning tool.

B. Conduct a hardness test for the carbide insert.

C. Take a hardness test for the chuck.

A. 列出了技术名称一个示例。

B. 列出的技术员名称只是示例。

C. 列出的技术名称只是示例。