A、 检查和观察是用于检查飞机内部和周围的舱室和设备的窗口,包括透明材料、框架等。
B、 检查窗和观察窗是用于检查飞机内部和飞机上的舱室和设备的窗口,包括透明材料、框架等。
C、 检查和观察是用于检查飞机内部和周围的舱室和设备的窗口,包括透明材料、其框架等项目。
答案:B
A、 检查和观察是用于检查飞机内部和周围的舱室和设备的窗口,包括透明材料、框架等。
B、 检查窗和观察窗是用于检查飞机内部和飞机上的舱室和设备的窗口,包括透明材料、框架等。
C、 检查和观察是用于检查飞机内部和周围的舱室和设备的窗口,包括透明材料、其框架等项目。
答案:B
A. 我们建议你不要在机库里执行此步骤。
B. 我们建议你不要在车间里执行此程序。
C. 我们推荐你不要在吊具上执行此过程。
A. The pump is installed behind the hydraulic motor.
B. The gearbox is installed behind the pneumatic motor.
C. The hydraulic motor is installed behind the pump.
A. Turbine press air is in the aft right body fairing.
B. The ram air turbine is located in the aft right body fairing.
C. The air pressed by turbine is located in aft right body fairing.
A. If the aircraft is parked on the ground, make sure that wheel chocks are placed.
B. If the aircraft is parked on the ground, make sure that wheel chocks are in position.
C. If the aircraft is parked on a slope, make sure that wheel chocks are in position.
A. 裂缝的最大长度为5英尺。
B. 裂缝的最大长度为5英寸。
C. 裂缝的最大深度为5英寸。
A. Aluminum wire should not be attached to engine mounted accessories or used in areas having corrosive fumes, severe vibration, mechanical stresses, or where there is a need for frequent disconnection.
B. Aluminum line should not be connected to attachments which are mounted on the engine and also not be applied in domains where corrosive gases, serious oscillation, mechanical forces exist or where it is necessary to disconnect frequently.
C. Aluminum cable should not be linked to accessories installed on the engine. It should also not be used in the event of corrosive fumes, serious vibration, mechanic loads or the place where frequent disconnections are required.
A. During the retraction test, keep a close watch on the monitor.
B. Continuously observe the indications after the retraction test.
C. Monitor the indications during the retraction test.
A. Exhale into the oxygen mask.
B. Breathe into the oxygen mask.
C. Breathe into the gas mask.
A. Release the hydraulic pressure in the accumulator.
B. Release the power pressure in the accumulator.
C. Release the hydraulic pressure in the actuator.
A. For data about the location of circuit breakers, refer to the wiring list.
B. Refer to the wiring list about the adapters location data.
C. For data about the location of circuit breakers, refer to the wiring diagram.