Drive shaft section is used to conduct power from the engine to the gearbox.

A. 为了便于阅读和交叉索引，图解说明、图形和表格实际上应以垂直布局呈现。

B. 为了便于阅读和相互参考，插图、图形和表格如果可行的话，应以垂直布局呈现。

C. 为了便于阅读和相互对照，示意图、插图和表格在实际情况下应以垂直布局呈现。

A. To give indications and test to the wing/body overheat system, 115v ac power must be connected. When installing an element, do not bend the element unless the bend radius is less than one inch. If the bend radius is less than one inch, damage to the eleme

B. For the indications and test of the wing/body overheat system, 115v ac power must be ON. When you install an element, do not bend the element until the bend radius is less than one inch. If the bend radius is less than one inch, damage to the element can

C. 115v dc power must be supplied for the indications and test of the wing/body overheat system. When you install an element, do not bend the element radius less than one inch. If you bend the radius less than one inch, damage to the element can occur.

A. 如果温度降到零度，开启排放水系统。

B. 如果温度下降到低于零，请拆卸水系统。

C. 如果温度降至零度以下，则将水系统排空。

A. 门是由碳纤维复合塑料制成的。

B. 门的主要成分是碳纤维复合材料。

C. 门是由碳纤维增强塑料制成的。

A. According to the "GAMA Specification No.1", compile the Pilots Operating Handbooks.

B. Prepare Pilots Operating Handbooks through "GAMA Specification No.1".

C. Edit "GAMA Specification No.1", in accordance with Pilots Operating Handbooks.

A. 快速定点必须与航迹的点吻合。

B. 夹具必须贴合导轨上的洞。

C. 紧固件必须和滑轨内的孔对准。

A. Sometimes, FAA and other airworthiness authority may accept the Continuing Airworthiness Program that uses the Specification.

B. Sometimes, we use the Specification to prepare a Continuing Airworthiness Program that will be accepted by non-FAA airworthiness authority.

C. Sometimes, during preparing a Continuing Airworthiness Program, using the Specification may be accepted by FAA and other airworthiness authority.

A. Rise the cylinder up its install position.

B. Lift the cylinder above its installed position.

C. Lift the bushings above its installing position.

A. 应说明最小机组人数，以及如果需要一名以上飞行机组人员时，还应说明每个机组人员的职责。

B. 需要一名以上飞行机组人员时，应说明最小机组人数和每个机组人员的职能说明。

C. 请按要求说明机组成员人数，以及每位机组成员的职能。

A. 传感器、指示器构成了机指示系统的主体部分，能够显示空气系统的温度、压力及控制位置等。

B. 发射机、指示器可用于显示空气系统的温度、压力、和控制位置等。

C. 发动机指示系统用于显示温度、压力以及空气系统的控制器位置，包括传感器、指示器等部件。