这个接触器有32个触点。

A. 使用符号代表电磁活门，显示该活门是否是弹簧加载到开位或关位。

B. 应针对电磁活门标明注意事项，说明该活门应该弹簧加载到开位还是关位。

C. 电磁活门应标有符号，表明该活门是弹簧加载到开位还是关位。

A. It is possible to use the same page to include the examples, associated conditions and technique. Should there be no necessary information included, refer to the page facing the chart.

B. If the same page contains examples, associated conditions and techniques, you need to include all the necessary information, it is forbidden to use the page that the figure faces.

C. Where possible, examples, associated conditions and technique should be presented on the same page as the chart. If space is not enough to include the necessary information, then the page facing the chart should be used.

A. 基本上，作者可以使用字典中已批准的词汇作为核心词。

B. 在主要部分中，作者可以使用字典中已认可的词汇作为核心词。

C. 在基础部分中，作者可以使用字典中已核实过的词汇作为核心词。

A. Emergency Exit means the exit doors used to facilitate evacuation that are not normally used for exit.

B. Emergency Exit is usually used as exit whose function is convenient for evacuation.

C. Emergency Exit stands for the exit doors but not the exit which is used to facilitate evacuation.

A. 功能测试应该包含进行性能测试所必要的所有信息，以保持系统或组件的可靠性在可接受的水平，而不用参考其他文件。

B. 功能测试包括所有必须的信息，无需参照附加文件，就可以执行为了保证系统及部件的可靠性而做的能力测试。

C. 不用参照其它材料，功能测试为了确保系统或组件的可靠性是可接受的而提供了所有必须的信息。

A. 生产商编写的维修手册必须参考本规范中包含的所有材料的格式、字体和展示方法。

B. 本手册中包含的规范可以指导厂家编写维修手册，包括所有规章书写格式和展示方法。

C. 本规范中包含的规则应作为制造商编写的维修手册中包含的所有材料的格式、样式和展示方法的指南。

A. Ground Idle Power refers to the power required to run an engine on the ground, as slowly as possible, yet sufficient to ensure satisfactory engine, engine accessory, and airplane operation with a minimum of thrust.

B. Ground Idle Power refers to the power required to run an engine as slowly as appropriate on the ground while still ensuring satisfactory airplane operation with a maximum of thrust of engine and engine accessory.

C. For Ground Idle Power, it determines the minimum power necessary to initiate and maintain safe airplane operation, engine accessory function, and satisfactory engine performance while limiting the degree of thrust utilized.

A. Rapid operation of the accelerometer can cause unexpected movement of the vertical stabilizer.

B. Accidental movement of the compass can cause unwanted operation of the oriental stabilizer.

C. Sudden operation of the gyro can cause unwanted movement of the horizontal stabilizer.

A. Make sure that the tab fully connects to the surface without bubbles.

B. Make sure that the label fully attaches to the surface and that there are no bubbles.

C. Make sure that the tag is fully engaged on the surface and no bubbles.

A. Do a tire pressure check, and if necessary inflate the tires.

B. Check the pressure of a wheel and charge it if necessary.

C. Inspect the tire pressure and it＇s required to refuel.