A、 The manufacturer may set up steps and feedback the airworthy conditions discovered when complying.
B、 The manufacturer may establish procedures to provide feedback on unairworthy conditions that were discovered when complying.
C、 The manufacturer may establish procedures and comply regulations to provide feedback on unairworthy conditions.
答案：B
A、 The manufacturer may set up steps and feedback the airworthy conditions discovered when complying.
B、 The manufacturer may establish procedures to provide feedback on unairworthy conditions that were discovered when complying.
C、 The manufacturer may establish procedures and comply regulations to provide feedback on unairworthy conditions.
答案：B
A. In the event of filler bonding to the tool, dip the tool in cold water.
B. If the filler bonds to the tool, avoid using water to moisten the tool.
C. If the filler sticks to the tool, make the tool wet by applying cold water.
A. If the right engine stops, what position will APU servo valve stop at?
B. If the right engine is not running,what position will APU bleed valve stop at?
C. If the right engine stops, will APU servo valve stop at close position?
A. Get the approval of the design authority,whatever it is necessary to change the repair scheme.
B. Change the repair scheme, until getting the approval of the design authority.
C. If it is necessary to change the repair scheme, get the approval of the design authority.
A. “力臂”是物体重心到基准面的水平距离。
B. “力臂”是物体重心到参考面的垂直距离。
C. “力矩”是物体中心到参考基准面的距离。
A. 机翼和发动机载荷取决于最大起飞重量和额定起飞马力以及机翼面积。
B. 机翼和电源负载取决于最大起飞重量和起飞马力评定值以及机翼面积。
C. 机翼和动力载荷决定了最大起飞重量和起飞马力评定值以及受力表面积。
A. Alternates for equipment may be listed under the same item number. For installations made up of a number of units which my be located at various places in the airplane, each unit should be listed separately.
B. Alternative equipment can be listed under the same item number. Multiple identical components installed in different locations of the aircraft should be listed uniformly.
C. Different equipment may be substituted for each other and listed under the same item number. Multiple identical units installed on different aircraft should be listed individually.
A. Put a plug on the open end of each pipe.
B. On the opening of each pipe, put a cover.
C. Put a cover on the loose end of the pipe.
A. 此程序可以在此服务通告中执行。
B. 在本服务通告中必须执行此程序。
C. 此程序必须在此咨询通告中执行。
A. 如果无法使用自动控制，请使用人工控制程序。
B. 用手动程序代替自动控制程序完成操作。
C. 尽可能使用手动程序取代自动控制。
A. The main oil/fuel heat exchanger uses the low temperature of the scavenge oil to reduce the fuel flow from the low pressure fuel pump.
B. The main oil/fuel heat exchanger uses fuel from the low pressure fuel pump to decrease the temperature of the scavenge oil.
C. The main oil/fuel heat exchanger sends fuel from the low pressure fuel pump to the scavenge oil lines to decrease the oil temperature.
