A、 Drill the hole until it has a radius of 8.00 +/- 0.003 mm.
B、 Ream the hole until it has a diameter of 8.00 +/- 0.003 mm.
C、 Trim the hole until it has a width of 8.00 +/- 0.003 mm.
答案:B
A、 Drill the hole until it has a radius of 8.00 +/- 0.003 mm.
B、 Ream the hole until it has a diameter of 8.00 +/- 0.003 mm.
C、 Trim the hole until it has a width of 8.00 +/- 0.003 mm.
答案:B
A. Turn the dimming knob and find out the intensity of the light changes.
B. Press the light exchange switch to observe the change of light intensity.
C. Operate the dimmer switch and make sure that the intensity of the light changes.
A. 符合规范的问题应提交给通用航空制造商协会(GAMA)和联邦航空管理局(FAA)解决。
B. 问题应符合规范,查阅通用航空制造商协会(GAMA)和联邦航空管理局(FAA)得到解决。
C. 遵守规范的问题应涉及到通用航空制造商协会(GAMA),并提交给联邦航空管理局(FAA)解决。
A. Check wash basin drains, water tap and its lines for leakage.
B. Inspect the washing sink, faucet and its pipe for leakage.
C. Examine the washing hand drain port, tap and the line for crack.
A. 飞机的维护信息必须与制造商提供的最近信息一致。
B. 飞机可根据制造商发布的最新信息进行维修。
C. 根据厂家最近出版的维修信息对飞机进行修理。
A. Maximum Landing Weight is maximum weight supplied for the landing contact.
B. Minimum Landing Weight is minimum weight provided for the landing touchdown.
C. Maximum Landing Weight is maximum weight approved for the landing touchdown.
A. Refer to FIG. 401 for the distance between rivets.
B. If you want to know the distance between bolts, refer to FIG. 401.
C. Look at FIG. 401 for the dimension between bolts.
A. In such cases, the introduction should notice the systems related in the manual,manufacturers may also choose to group related systems where the simplicity of the product permits.
B. In such cases, the introduction should note the systems covered in the manual,manufacturers may also choose to group related systems where the simplicity of the product permits.
C. In such cases, the introduction should note the systems comprised in the manual,manufacturers may also choose to divide related systems if the product is simple enough.
A. The values must be less than the approved differences.
B. The values must not exceed the allowable differences.
C. The values must be less than the allowable differences.
A. Adjust the frequency to the value giving in table 1.
B. Adjust the frequency per the value given in table 1.
C. Adjust the frequency to the value given in table 1.
A. The inlet door actuator is installed aft of the rear pressure bulkhead on the inner side of the air inlet door.
B. The air inlet actuator is mounted on the side of the pressure bulkhead behind the intake valve.
C. The air release actuator is located on top of the pressure bulkhead inside the intake valve.