A、 ln either case, a chart will be included in showing standard symbols used throughout the manual.
B、 ln both cases, a figure will be contained to show the normal symptoms used in the whole manual.
C、 Through-the handbook, a form shall be used to show the normal signs in these two cases.
答案：A
A、 ln either case, a chart will be included in showing standard symbols used throughout the manual.
B、 ln both cases, a figure will be contained to show the normal symptoms used in the whole manual.
C、 Through-the handbook, a form shall be used to show the normal signs in these two cases.
答案：A
A. 电瓶为紧急出口的照明电路供电
B. 闭合电瓶电路给应急出口灯供电:
C. 应急出口灯由电瓶电路控制
A. 显示器顶部和左侧角落的数字指向相关页面。
B. 显示器左上角的数字代表手册对应页码。
C. 显示器左上角的数字代表相关页面。
A. The maximum distance between the plate edge and the frame is inferior to 0.05mm.
B. The clearance between the boundary of the panel and the bay can not exceed 0.05mm.
C. The distance between the edge of the panel and the partition must not be more than 0.05mm
A. The operational test of HFS-900D transceivers is internal functions check of the HF transceiver and it is a
B. The BITE test for the HFS-900D transceivers is the operation test that does the inner check of the HF
transceiver.
C. The check of the internal functions of the HF transceiver is a BITE test related to HFS-900Dtransceivers.
A. A reporting system, consistent with the system applied by the ABC Service organization, has been
established and included in this document.
C. A reporting system, constituent with the system employed by the ABC Service organization, has been
established and accomplished in this document.
A. The compressing of the spring can cause the valve to open.
B. There is no change of the valve when the spring compresses.
C. After compressing of the spring, the valve goes to closed position.
A. Setting cable tension, flight control surfaces travel limits and stops are the main tasks of rigging.
B. Cable tension set, flight controls travel limits adjustment and travel stops set are the rigging procedures.
A. To evaluate the effectivity of the recommended inspection procedures and time intervals, it' s mandatory
to inform the ABC Aircraft Company of the significant details of inspection results, repairs and modifications
accomplished.
B. Repairs and modifications accomplished that are resulted from the significant details of inspection must be
reported to the ABC Aircraft Company to assess whether the recommended inspection procedures and time
intervals are effective.
C. Communications with ABC Aircraft Company about the significant details of inspection results, repairs and
modification accomplished is necessary for the purpose to verify the effect of the recommended inspection
procedures and time intervals.
A. Schematic diagram designers may make a compromise so as to add more details to make the diagram
self-explanatory and keep its simplicity at the same time for ease of reading and understanding.
B. ln designing schematic diagrams, It may be necessary to pay attention to both detail that is necessary to
make the diagram self-explanatory and simplicity that is essential for ease of reading and understanding.
C. Detail makes the diagram self-explanatory、 Simplicity makes it easy to read and understand is necessary to
consider both of them and make a compromise if needed when designing schematic diagrams.
A. Even though this specification is conformed to recognized industry practices,
it is prepared in broad
genuine terms and it is recognized that problems will occur which are not handled enough by the
specification.
B. Although this specification coheres with recognized industry practices, it is written in vast general terms
and it is asserted that problems will appear which are not treated sufficiently by the specification.
C. Though this specification complies with accepted industry practice, it is compiled in wide generic terms
and it is recognized that problems which are not treated adequately by the specification will arise.
