A、 Drill the hole until it has a radius of 8.00+/-0.003 mm.
B、 Ream the hole until it has a diameter of 8.00+/- 0.003 mm.
C、 Trim the hole until it has a width of 8.00+/--0.003 mm.
答案:B
A、 Drill the hole until it has a radius of 8.00+/-0.003 mm.
B、 Ream the hole until it has a diameter of 8.00+/- 0.003 mm.
C、 Trim the hole until it has a width of 8.00+/--0.003 mm.
答案:B
A. lf you find damaged lines, restore them.
B. lf you find loosen cables, fix them.
C. lf you find broken wires, repair them.
A. 当释放液压时,活门按顺序打开
B. 当液压被释放后,顺序活门移动到开位。
C. 当液压增压时,要按顺序移动来打开活门。
A. 为防止损坏发动机,立即打开所有安装的防护罩。
B. 为防止损坏发动机,稍候装上所有开口的防护罩。。
C. 为防止损坏发动机,立即在所有开口上安装防护罩。
A. Do not replace the self-locking nuts with plain nuts.
B. Do not use a general fastener instead of a self-locking one.
C. The general purpose nut is interchangeable with the self-locking nut.
A. Landing gear is left for ten minutes.
B. Landing gear should be kept extended(伸出) for ten minutes
C. Extend landing gear after ten minutes' retraction.
A. 速度-高度纠错系统通过修正实际速度尽可能保持飞机安全飞行高度。
B. 通过修正实际速度尽可能保持飞机安全飞行高度的任务由速度-高度纠错系统完成。
C. 速度-姿态修正系统通过修正速度的影响,自动保持安全的飞行姿态。
A. See the graphics for information of the solenoid valves which shall contain a note indicating the position
of the valve(weather spring-loaded to its open or closed position).
B. Solenoid valves indicated on the schematic shall have a notation indicating when the valve shall be
spring-loaded to the open or closed position.
C. Solenoid valves shall be indicated on the schematic and shall include a notation indicating whether the
valve is spring-loaded to the open or closed position.
A. A reporting system, consistent with the system applied by the ABC Service organization, has been
established and included in this document.
C. A reporting system, constituent with the system employed by the ABC Service organization, has been
established and accomplished in this document.
A. Do not operate the brakes to decrease the pressure in the accumulators.
B. Do not control the brakes to increase the pressure in the accumulators.
C. Do not maneuver the brakes for augmentation of the pressure in the reservoir
A. 手册中所示的度量单位必须准确
B. 手册中的度量单位必须一致
C. 手册中的度量单位必须写明