A、 The condenser decreases the temperature of the air in the air conditioning pack to below the dew point,
changing water vapor into liquid. were
B、 The cooler lowers the air temperature to the boiling point in the air conditioning module, which can
transfer the steam into water.
C、 The evaporator turns steam into liquid by reducing the temperature of the air in the air conditioning pack
to the evaporating point
答案：A
A、 The condenser decreases the temperature of the air in the air conditioning pack to below the dew point,
changing water vapor into liquid. were
B、 The cooler lowers the air temperature to the boiling point in the air conditioning module, which can
transfer the steam into water.
C、 The evaporator turns steam into liquid by reducing the temperature of the air in the air conditioning pack
to the evaporating point
答案：A
A. This procedure is only applicable to type A parts.
B. This task is only used for type A parts.
C. This procedure is applicable to all type parts.
A. The procedures should give the address of the facility and time the program will be rechecked to find out
if it is coherent enough for the type of maintenance being performed at the facility.
B. The program shall be checked to decide if it is updated and sufficient for the type of maintenance being
performed at the facility. The interval of the checks shall be stated in this procedure
C. The program will not be performed at the facility if this procedure shows outdated and inadequacy
information for the the type of maintenance.
A. The correctness of this adjustment is important.
B. This adjustment is wrong.
C. The importance of the adjustment is correct
A. The forward and aft edges of the windshield has limits, otherwise the bottom and the top edge has not
limits.
B. Because of the visibility of the bottom edge of the windshield and the top edge having the bus bar in the
way, the forward and aft edges of the windshield will be limited.
C. This will be limited to the forward and aft edges of the windshield because of the bottom edge invisible
and the top edge having the bus bar in the way.
A. Pull out the circuit breaker.
B. Push in the circuit breaker.
C. Remove the circuit breaker.
A. If there is a available service bulletin to correct the problem of moisture ingress into the connector cavity,
the letter then will be useless.
B. Refer to this letter to help mitigate moisture ingress into the connector cavity even if there is a available
service bulletin to correct the problem.
C. If there is a available service bulletin to correct the problem that moisture ingress into the connector cavity,
the letter then will provide procedures.
A. It is necessary to define symbols, symbols, abbreviations and terminology for the dear understanding of
the information presented in various sections of the Handbook.
B. Define signatures, short words and jargon necessary for understanding clearly of the information
contained in every section of the Handbook.
C. It is important to define signs, acronyms and nomenclature for the understanding of the information
provided in this section of the Handbook.
A. For more information, refer as official reference books.
B. For more information, refer to official reference books.
C. More information referred to official reference books.
A. 当火警启动时,温度增加并引起灭火器工作。
B. 当火焰开如时,温度增加并造成触发器工作,
C. 当起火时,温度升高并使探测器工作。
A. “维护操作”包括维修 拆卸/安装、调整/测试检测/检查、清洁/喷漆和批准的维修,应遵循故障排除部分
B. “维护操作“包括维修、拆卸/安装、调整/测试检测/检查、清洁/喷漆和正当的维修,,应遵循故障排除部分
C. “维护操作”包括维修、拆卸/安装、调整/测试检测/检查、铲除/喷漆和批准的维修,应遵循故障排除部分
